2007 Kenworth T300 Recalls, Complaints & Specs
5 safety recalls list the 2007 Kenworth T300, and owners have filed 3 complaints with NHTSA. Check your own VIN below.
5 safety recalls for the 2007 Kenworth T300
Most recent first. Recall repairs are free at any authorised dealer. Click a recall for the full defect, consequence and remedy text.
-
Hoses, lines/piping, and fittings (fuel system)
Paccar is recalling 36 my 2007-2008 t270, t370 and my 207 t300 trucks equipped with dual under-cab fuel tanks and an in-cab battery box (icbb). A harness support bracket mounted on the underside of the cab may come in contact with the fuel line at the top of the fuel splitter valve.
Remedy: Dealers will re-work the existing icbb cable routing bracket and replace the fuel splitter valve bracket to provide adequate clearance between components. The recall began o june 30, 2008. Owners may contact kenworth…
-
Electrical system
On certain trucks equipped with cummins isc or paccar px8 engines, the jumper wire between the grid heater relay to the fuse block has been routed in such a way that the potential exists for it to rub against the radiator support.
Remedy: Dealers will inspect the routing of the jumper wire. If the wire is not routed correctly, it will be inspected for rubbing or chaffing and replaced if necessary free of charge. The recall began on june 22, 2007. Owners…
-
Axle assembly (power train)
On certain trucks, the axle housings may have been manufactured with steel that was out of specification which could result in a fatigue failure over time.
Remedy: Dealers will inspect and replace the axles free of charge. The recall began on may 9, 2007. Owners may contact kenworth at 425-828-5440 and peterbilt at 1-940-591-4196.
-
Automatic transmission (power train)
On certain trucks, the wiring, parts, or transmission programming required for the auto neutral feature to function as designed were either not installed, connected, or programmed properly.
Remedy: Dealers will inspect the affected vehicles to ensure the auto neutral feature functions properly and, if needed, will make the necessary repairs free of charge. The recall began on may 9, 2007. Owners may contact…
-
Service brakes, air
Certain trucks fail to comply with the requirements of federal motor vehicle safety standard no. 121, "air brake systems." the trailer light line may have been routed using too tight of a bend radius. This routing method could cause the wires within the harness plug to be pulled away from the chassis plug resulting in an intermittent or…
Remedy: Dealers will reroute the light line to eliminate the excessive bend radius and replace any plug or harness that has been damaged free of charge. The recall began on april 16, 2007. Owner may contact kenworth at…
3 owner complaints filed with NHTSA
Owners of the 2007 Kenworth T300 have filed 3 complaints with NHTSA. The average mileage at failure in those reports is 90,000 miles. Complaints peaked in 2008 with 3 filed that year.
Most-reported components
What owners are reporting
“Tl*the contact owns a 2007 kenworth t300. While driving approximately 18 MPH, the steering wheel locked when a left turn was made. The contact heard an excessively loud noise at the time of the failur”
Owner complaint to NHTSA, August 28, 2008 · Steering
“Tl*the contact owns a 2007 kenworth t300. While driving approximately 18 MPH, the steering wheel locked when a left turn was made. The contact heard an excessively loud noise at the time of the failur”
Owner complaint to NHTSA, August 28, 2008 · Steering
Compare Kenworth T300 model years
Recall and complaint counts for every Kenworth T300 model year in NHTSA's database.
Checking a specific 2007 Kenworth T300
How do I know if my 2007 Kenworth T300 has an open recall?
Enter your 17-character VIN above. The VIN is on the driver's side dashboard (visible through the windshield), the driver's door jamb sticker, and your registration or insurance card. The check runs against NHTSA's live database and tells you which campaigns list your vehicle. 5 campaigns currently list the 2007 Kenworth T300; your car may already have been repaired under some of them.
Is the recall repair free?
Yes. Under federal law, manufacturers must fix safety recalls at no charge for vehicles up to 15 years old from the date of sale to the first owner. Contact any authorised Kenworth dealer with your VIN and the NHTSA campaign number (for example 07V073000).
What is the difference between a recall and a complaint?
A recall is a safety campaign filed by the manufacturer or ordered by NHTSA, with a defined defect and remedy. A complaint is a report an owner sent to NHTSA; it is not verified, but patterns of complaints are what trigger NHTSA investigations and, eventually, recalls.
Other Kenworth models
- T68077 complaints
- T200038 complaints
- T80033 complaints
- W90032 complaints
- Kenworth23 complaints
- T60016 complaints
- Conventional10 complaints
- T88010 complaints
Source: NHTSA recall and complaint databases and EPA fuel economy data, October 2026. Complaint counts are owner reports to NHTSA, not verified defects. Recall counts are safety campaigns that list this model year; whether a particular car was already repaired depends on its VIN. How this data is compiled.