Skip to content

2010 Kenworth T660 Recalls, Complaints & Specs

10 safety recalls list the 2010 Kenworth T660, and owners have filed 2 complaints with NHTSA. Check your own VIN below.

10
safety recalls
2
owner complaints to NHTSA
1 / 0
complaints citing a crash / fire

10 safety recalls for the 2010 Kenworth T660

Most recent first. Recall repairs are free at any authorised dealer. Click a recall for the full defect, consequence and remedy text.

  1. Reservoir/tank (service brakes)

    NHTSA 24V145000 Reported 936 vehicles potentially affected PACCAR Incorporated

    PACCAR Incorporated (PACCAR) is recalling certain 2009-2021 Kenworth C500, 2012-2021 Kenworth T440, 2009-2015 Kenworth T660, 2015-2024 Kenworth T680, 2009-2024 Kenworth T800, 2009-2020 Kenworth T370, 2014-2023 Kenworth T880, 2011-2016 Kenworth T470, 2023 Kenworth T480, and 2009-2019 Kenworth W900 vehicles. The air tanks have an…

    Remedy: Dealers will install the correct volume air tanks, free of charge. Owner notification letters were mailed August 12, 2024. Additional owner notification letters were mailed October 27, 2025. Owners may contact PACCAR…

  2. Electronic stability control (esc) and abs warning light (service brakes)

    NHTSA 20V199000 Reported 460,515 vehicles potentially affected PACCAR Incorporated

    PACCAR Incorporated (PACCAR) is recalling certain 2008-2019 Peterbilt 330, 335, 337, 340, 348, 365, 367, 384, 386, 387, 388, 389, 567, 579 and 587 vehicles and 2008-2020 Kenworth T170, T270, T370, T660, T680, T800, T880, and W900 vehicles equipped with NAMUX Software. In the event that the Anti-lock Brake System (ABS) loses battery…

    Remedy: PACCAR will notify owners, and dealers will update the NAMUX software within the cab control module, free of charge. PACCAR issued owners an interim notification on June 4, 2020. The recall began May 26, 2020. Owners…

  3. Engine and engine cooling

    NHTSA 11V203000 Reported 5,831 vehicles potentially affected PACCAR INCORPORATED

    Paccar is recalling certain model year 2007-2011 kenworth c500, t2000, t600, and t660, as well as model year 2009-2011 peterbilt 387 and 388 trucks equipped with caterpillar c15 engine and manufactured from may 11, 2006, through september 17, 2010. Degradation of a combustion tube weld can cause radial heat impingement on the body which…

    Remedy: Caterpillar is handling the owner notification and remedy for this campaign. Please see caterpillar's defect report 11e-006. Caterpillar will replace the single piece combustion tube with a thick wall combustion tube…

  4. Tank assembly (fuel system)

    NHTSA 11V127000 Reported 4,664 vehicles potentially affected PACCAR INCORPORATED

    Paccar is recalling certain model year 2008-2012 kenworth t2000, t660, t700, t800, and w900, as well as model year 2009-2012 peterbilt 365, 367, 384, 386, 387, 388, 389, and 587 trucks equipped with paccar mx engines. The oil module centrifugal spinner filter cap in the paccar mx engine may become loose, possibly allowing the cap to…

    Remedy: Dealers will re-torque the oil module filter cap and install a secondary retention device on the secondary centrifugal spinner filter cap. This service will be performed free of charge. The safety recall is expected to…

  5. Caliper (service brakes)

    NHTSA 10V535000 Reported 417 vehicles potentially affected PACCAR INCORPORATED

    Paccar is recalling certain model year kenworth t660, t700, t800 and w900 vehicles manufactured from december 22, 2008, through august 2, 2010, and equipped with ag400l air disc brakes. The air disc brake caliper could be installed on the wrong side of the drive axle potentially causing interference with the suspension bracket and the…

    Remedy: Dealers will verify the correct orientation of the brake caliper and perform the necessary repair free of charge. The safety recall began on november 24, 2010. Owners may contact kenworth at 425-828-5440.

  6. Column (steering)

    NHTSA 10V308000 Reported 9,697 vehicles potentially affected PACCAR INCORPORATED

    Paccar is recalling certain model year 2008-2010 trucks equipped with trw steering shafts. The circumferential weld around the steering shaft tube that welds the splined tube to the non-splined tube may be mislocated. Mislocation of the circumferential weld may allow the splined tube and non-splined tube to rotate relative to one…

    Remedy: Dealers will inspect the steering shaft using a weld placement gauge provided by trw. Any steering shaft found to have been welded improperly will be replaced free of charge. The safety recall began on july 30, 2010.…

  7. Latch (latches/locks/linkages)

    NHTSA 10V266000 Reported 4,796 vehicles potentially affected PACCAR INCORPORATED

    Kenworth is recalling certain model year 2009 through 2010 t660 tractor trailors manufactured from july 1, 2008 through july 31, 2009. The retaining pins securing the hood strut lock tube to the hood strut assembly may become loose and fall out allowing the lock tube to rotate on the strut assembly. In its normal operation the safety…

    Remedy: Dealers will replace the pivot disc and lock tube retaining pins with a revised pivot disc and cap screws. This service will be performed free of charge. The safety recall began on july 15, 2010. Owners may contact…

  8. Spindle (suspension)

    NHTSA 10V185000 Reported 21 vehicles potentially affected PACCAR INCORPORATED

    Kenworth is recalling certain model year 2010 t2000, t660, t800 and w900 vehicles manufactured between july 30, 2009 and september 18, 2009. The rear axle outer end hub may have not been primed with oil properly during the rear axle installation process. Potential lack of oil may cause the outer end bearing to heat up and/or seize,…

    Remedy: Dealers will replace the bearings, seals and will add oil to the outer end hub as well as inspect races and axle housing for damage and replacing as necessary free of charge. The safety recall began on may 24, 2010.…

  9. Steering

    NHTSA 09V490000 Reported 3,078 vehicles potentially affected PACCAR INCORPORATED

    Kenworth is recalling model year 2010 t2000, t800, t660 and w900s trucks manufactured between july 1 and october 23, 2009. The fasteners attaching the steering gear to the front drive bracket may have received insufficient torque during the installation process resulting in less than required clamp load.

    Remedy: Dealers will inspect and re-torque the steering gear mounting bolts free of charge. The safety recall is expected to begin during january 2010. Owners may contact kenworth at 1-425-828-5440.

  10. Axle assembly (power train)

    NHTSA 09V415000 Reported 914 vehicles potentially affected PACCAR INCORPORATED

    Kenworth is recalling model year 2009 through 2010 t2000, t800, t660 and w900 trucks manufactured between november 12, 2008 and september 30, 2009. The axle u-bolts attaching the axle to the suspension leaf spring on certain ag400l rear suspensions may have received insufficient fastener torque during the installation process. The…

    Remedy: Dealers will inspect the axle u-bolts for visible defects, including bent and/or smashed threads and re-torque the axle u-bolts to factory specifications. The recall began on november 4, 2009. Owners may contact…

2 owner complaints filed with NHTSA

Owners of the 2010 Kenworth T660 have filed 2 complaints with NHTSA; 1 describe a crash. Reports cite 1 injury and 0 deaths. The average mileage at failure in those reports is 152,613 miles. Complaints peaked in 2011 with 2 filed that year.

Most-reported components

What owners are reporting

“While going down long mountain grades, in hot weather, the steering locks up. I was told that it needed a oil cooler. I paid $1280.00 for an oil cooler. Trw does not think they have any responsibility”

Owner complaint to NHTSA, September 22, 2011 · Steering

“Tl* the contact owns a 2010 kenworth t660 truck. While driving approximately 10 MPH, the contact attempted to depress the brake pedal when he noticed that the vehicle was hesitant to stop. The contact”

Owner complaint to NHTSA, May 10, 2011 · Service brakes, hydraulic

Compare Kenworth T660 model years

Recall and complaint counts for every Kenworth T660 model year in NHTSA's database.

Model yearRecallsComplaints
2004 Kenworth T66020
2005 Kenworth T66040
2006 Kenworth T66040
2007 Kenworth T66080
2008 Kenworth T660142
2009 Kenworth T660170
2010 Kenworth T660102
2011 Kenworth T660131
2012 Kenworth T66091
2013 Kenworth T66060
2014 Kenworth T660111
2015 Kenworth T660110
2016 Kenworth T660100
2017 Kenworth T66060
2018 Kenworth T66060
2019 Kenworth T66050
2020 Kenworth T66010

Checking a specific 2010 Kenworth T660

How do I know if my 2010 Kenworth T660 has an open recall?

Enter your 17-character VIN above. The VIN is on the driver's side dashboard (visible through the windshield), the driver's door jamb sticker, and your registration or insurance card. The check runs against NHTSA's live database and tells you which campaigns list your vehicle. 10 campaigns currently list the 2010 Kenworth T660; your car may already have been repaired under some of them.

Is the recall repair free?

Yes. Under federal law, manufacturers must fix safety recalls at no charge for vehicles up to 15 years old from the date of sale to the first owner. Contact any authorised Kenworth dealer with your VIN and the NHTSA campaign number (for example 09V415000).

What is the difference between a recall and a complaint?

A recall is a safety campaign filed by the manufacturer or ordered by NHTSA, with a defined defect and remedy. A complaint is a report an owner sent to NHTSA; it is not verified, but patterns of complaints are what trigger NHTSA investigations and, eventually, recalls.

Other Kenworth models

Source: NHTSA recall and complaint databases and EPA fuel economy data, October 2026. Complaint counts are owner reports to NHTSA, not verified defects. Recall counts are safety campaigns that list this model year; whether a particular car was already repaired depends on its VIN. How this data is compiled.