NHTSA Recall 10V185000: Spindle (suspension)
PACCAR INCORPORATED reported this safety recall to NHTSA on , covering an estimated 21 vehicles. It affects 4 models including the Kenworth T2000.
| NHTSA campaign | 10V185000 |
|---|---|
| Manufacturer campaign | 10KWB |
| Component | SUSPENSION › REAR › AXLE › SPINDLE |
| Report received | May 4, 2010 |
| Owner notification | May 24, 2010 |
| Initiated by | Manufacturer |
Defect
Kenworth is recalling certain model year 2010 t2000, t660, t800 and w900 vehicles manufactured between july 30, 2009 and september 18, 2009. The rear axle outer end hub may have not been primed with oil properly during the rear axle installation process. Potential lack of oil may cause the outer end bearing to heat up and/or seize, possibly resulting in the overheating of the wheel end.
Safety risk
A wheel end fire may occur, increasing the risk of a crash.
Remedy
Dealers will replace the bearings, seals and will add oil to the outer end hub as well as inspect races and axle housing for damage and replacing as necessary free of charge. The safety recall began on may 24, 2010. Owners may contact kenworth at 425-828-5440.
Notes
Kenworth recall no. 10kwb.owners may also contact the national highway traffic safety administration's vehicle safety hotline at 1-888-327-4236 (tty 1-800-424-9153), or go to <a href=http://www.safercar.gov>http://www.safercar.gov</a> .
Vehicles covered by recall 10V185000
Being listed here means the campaign covers the model year, not that every car was built with the defect or is still unrepaired. Enter your VIN above to check your specific vehicle. Recall repairs are free at authorised dealers. Source: NHTSA, October 2026.