White GMC Acl Recalls & Complaints by Model Year
NHTSA lists 8 safety recalls and 0 owner complaints across 13 model years of the White GMC Acl (1986–1998).
Pick your White GMC Acl model year
| Model year | Recalls | Complaints |
|---|---|---|
| 1998 White GMC Acl | 1 | 0 |
| 1997 White GMC Acl | 1 | 0 |
| 1996 White GMC Acl | 2 | 0 |
| 1995 White GMC Acl | 5 | 0 |
| 1994 White GMC Acl | 4 | 0 |
| 1993 White GMC Acl | 2 | 0 |
| 1992 White GMC Acl | 1 | 0 |
| 1991 White GMC Acl | 2 | 0 |
| 1990 White GMC Acl | 1 | 0 |
| 1989 White GMC Acl | 1 | 0 |
| 1988 White GMC Acl | 2 | 0 |
| 1987 White GMC Acl | 1 | 0 |
| 1986 White GMC Acl | 1 | 0 |
All White GMC Acl recalls (8)
Every NHTSA safety campaign that lists a White GMC Acl, most recent first, with the model years each one covers.
-
Lines and fittings (suspension)
Vehicle description: class 8 heavy duty trucks. The air suspension control valve supply line was not plumbed through an air pressure protection valve. In the event of a failure, there would be loss of air pressure in the 'b' system air reservoir that supplies air pressure for the front steer axle brakes.
Remedy: Dealers will install the necessary air pressure protection valve.
Model years: 1986, 1987, 1988, 1989, 1990, 1991, 1992, 1993, 1994, 1995, 1996, 1997, 1998
-
Service brakes, air
The traction solenoid exhaust can be obstructed due to inadequate drainage and a build-up of road contamination between the mounting bracket and the solenoid housing. The obstructed exhaust prevents the relay valve control air pressure from venting after a differential braking traction event.
Remedy: Dealers will remove the suspect valve and install a new valve that has a modified solenoid housing which will allow for sufficient drainage and a new valve mounting bracket with increased height to reduce entry of…
-
Air suspension system (suspension)
The rear suspension axle retention plate can break under normal use, affecting axle alignment.
Remedy: Dealers will remove and replace the axle retention clip plates on affected vehicles.
Model years: 1995
-
Service brakes, air: controls, pedals and linkages
Undercoating applied to the inside of the cab shell squeezed out during assembly onto the brake pedal plunger.
Remedy: Dealers will clean the undercoating from the brake pedal plunger assembly, lubricate and reinstall the brake pedal plunger assembly.
-
Idler and attachment (steering)
Two bolts attaching the upper steering arm to the front steering axle were not tightened properly.
Remedy: Dealers will install new bolts and tighten to proper torque specification.
Model years: 1995
-
Electrical system: wiring
The main electrical power harness was misrouted. If there was an electrical short in this harness, the circuit would not be fuse-protected.
Remedy: Dealers will reroute the subject power harness and reconnect the affected wires to the correct fuse-protected power junction.
Model years: 1993, 1994
-
Linkages (steering)
The pinch bolt used to retain the pitman arm to the steering gear may not meet the heat treat specification for a grade 8 fastener and may strip before proper torque is achieved.
Remedy: Replace the pinch bolts with properly heat treated bolts.
Model years: 1991
-
U-bolt, leaf spring to axle (suspension)
Incorrect bolts may have been used to attach the rear suspension to the crossmember.
Remedy: Install correct bolts.
Model years: 1988
Other White GMC models
- White GMC4 complaints
- Wca3 complaints
- Aero1 complaints
- ACL42B0 complaints
- Aclf0 complaints
- Aclff0 complaints
- Aclft0 complaints
- Acm0 complaints
Source: NHTSA recall and complaint databases and EPA fuel economy data, October 2026. Complaint counts are owner reports to NHTSA, not verified defects. Recall counts are safety campaigns that list this model year; whether a particular car was already repaired depends on its VIN. How this data is compiled.