Skip to content

NHTSA Recall 06V169000: Linkages (steering)

HINO MOTORS SALES U.S.A., INC. reported this safety recall to NHTSA on , covering an estimated 5,072 vehicles. It affects 8 models including the Genie TZ-50.

5,072
vehicles potentially affected
8
models affected
2006
owners notified (May 12)
NHTSA campaign06V169000
Manufacturer campaignM0050
ComponentSTEERING › LINKAGES
Report receivedMay 18, 2006
Owner notificationMay 12, 2006
Initiated byManufacturer

Defect

On certain trucks, during assembly, the drag link attachment nuts at the pitman arm and steering arm may have been incorrectly torqued. Residual grease and paint which was applied as a rust inhibitor on the steering arm may have contributed to a loss of torque after assembly.

Safety risk

Increased wear for the draglink connections can occur creating a noticeable increase in the amount of steering wheel free play. If this condition was ignored, a loss of steering control of the vehicle could occur which could result in a crash.

Remedy

Dealers will inspect the steering arm tightness and remove all grease and paint from the steering arms and retorque the draglink attachment nuts at the steering arm and pitman arm. The recall began on may 12, 2006. Owners may contact hino at 1-248-648-6430.

Notes

Hino recall no. M0050.customers may also contact the national highway traffic safety administration's vehicle safety hotline at 1-888-327-4236 (tty 1-800-424-9153), or go to http://www.safercar.gov.

Vehicles covered by recall 06V169000

Make and modelModel years
Genie TZ-502004, 2005
Hino NA6J2005, 2006, 2007
Hino NB6J2005, 2006, 2007
Hino NC6J2005, 2006, 2007
Hino ND6J2005, 2006, 2007
Hino NE8J2005, 2006
Hino NJ8J2005, 2006
Hino NV8J2005, 2006, 2007

Being listed here means the campaign covers the model year, not that every car was built with the defect or is still unrepaired. Enter your VIN above to check your specific vehicle. Recall repairs are free at authorised dealers. Source: NHTSA, October 2026.