Skip to content

1993 International Harvester 3600 Recalls, Complaints & Specs

6 safety recalls list the 1993 International Harvester 3600. Check your own VIN below.

6
safety recalls
0
owner complaints to NHTSA

6 safety recalls for the 1993 International Harvester 3600

Most recent first. Recall repairs are free at any authorised dealer. Click a recall for the full defect, consequence and remedy text.

  1. Switch (exterior lighting)

    NHTSA 96V192000 Reported 171,638 vehicles potentially affected INTERNATIONAL TRUCK AND ENGINE

    These buses have a turn signal lever that will not operate consistently in the lane change mode if the lever is not moved to the position where resistance to movement is felt.

    Remedy: Operators will be mailed information concerning the proper method of using turn signals. A decal will also be provided to be placed on the instrument panel of each bus.

  2. Antilock/traction control/electronic limited slip (service brakes)

    NHTSA 96V174000 Reported 580 vehicles potentially affected INTERNATIONAL TRUCK AND ENGINE

    The wiring from the electronic control unit was connected to the wrong wheel sensor or to the wrong brake modulator valve. It is possible that either or both wiring may have occurred at either the front or rear axle or both axles.

    Remedy: Dealers will inspect the ABS wiring and, if necessary, properly connect.

  3. Hoses, lines/piping, and fittings (fuel system)

    NHTSA 95V179000 Reported 745 vehicles potentially affected INTERNATIONAL TRUCK AND ENGINE

    The fuel hose to the fuel filter is routed too close to the alternator belt causing the alternator belt to rub the fuel hose. This can cause a fuel leak.

    Remedy: Dealers will strap the fuel hose to the chassis frame to insure a minimum of 2 1/2" clearance between the fuel hose and the alternator belt.

  4. Hoses, lines/piping, and fittings (service brakes)

    NHTSA 93V188000 Reported 942 vehicles potentially affected INTERNATIONAL TRUCK AND ENGINE

    The hydraulic steel brake lines from the master cylinder to the frame fittings are experiencing vertical flexing which causes fatigue cracks at the frame end of the assembly, resulting in brake fluid leakage. This can occur in one or both of the steel brake lines. In either case, the brake warning light will come on and the low pressure…

    Remedy: Navistar dealers will install a new, redesigned primary and secondary brake line from the master cylinder to the frame rail fittings.

  5. Air suspension system (suspension)

    NHTSA 93V092000 Reported 193 vehicles potentially affected INTERNATIONAL TRUCK AND ENGINE

    The pressure relief valve was omitted in the air tank. The air tank is the reservoir for the air suspension and is not brake related. Without the pressure relief valve, there is no back-up system to limit air pressure in the air suspension system.

    Remedy: Install a pressure relief valve in the air tank.

  6. Linkages (vehicle speed control)

    NHTSA 93V025000 Reported 598 vehicles potentially affected NAVISTAR INTL CORP.

    The bracket that supports and positions the hand throttle cable at the accelerator rod can be bent or misaligned during body assembly to the chassis.

    Remedy: Replace the current throttle cable bracket with a new bracket; install at a different location.

No owner complaints on file

NHTSA has no owner complaints on file for the 1993 International Harvester 3600. For context, the average model year in NHTSA's database has dozens; a zero can mean a reliable vehicle, a rare one, or both.

Compare International Harvester 3600 model years

Recall and complaint counts for every International Harvester 3600 model year in NHTSA's database.

Model yearRecallsComplaints
1979 International Harvester 360010
1980 International Harvester 360010
1981 International Harvester 360020
1982 International Harvester 360020
1983 International Harvester 360020
1984 International Harvester 360020
1985 International Harvester 360020
1986 International Harvester 360020
1987 International Harvester 360020
1988 International Harvester 360020
1989 International Harvester 360020
1991 International Harvester 360040
1992 International Harvester 360080
1993 International Harvester 360060
1994 International Harvester 360060
1995 International Harvester 360030
1996 International Harvester 360010
1999 International Harvester 360010
2000 International Harvester 360010
2001 International Harvester 360010

Checking a specific 1993 International Harvester 3600

How do I know if my 1993 International Harvester 3600 has an open recall?

Enter your 17-character VIN above. The VIN is on the driver's side dashboard (visible through the windshield), the driver's door jamb sticker, and your registration or insurance card. The check runs against NHTSA's live database and tells you which campaigns list your vehicle. 6 campaigns currently list the 1993 International Harvester 3600; your car may already have been repaired under some of them.

Is the recall repair free?

Yes. Under federal law, manufacturers must fix safety recalls at no charge for vehicles up to 15 years old from the date of sale to the first owner. Contact any authorised International Harvester dealer with your VIN and the NHTSA campaign number (for example 93V025000).

What is the difference between a recall and a complaint?

A recall is a safety campaign filed by the manufacturer or ordered by NHTSA, with a defined defect and remedy. A complaint is a report an owner sent to NHTSA; it is not verified, but patterns of complaints are what trigger NHTSA investigations and, eventually, recalls.

Other International Harvester models

Source: NHTSA recall and complaint databases and EPA fuel economy data, October 2026. Complaint counts are owner reports to NHTSA, not verified defects. Recall counts are safety campaigns that list this model year; whether a particular car was already repaired depends on its VIN. How this data is compiled.