Chevrolet P20 Recalls & Complaints by Model Year
NHTSA lists 10 safety recalls and 0 owner complaints across 14 model years of the Chevrolet P20 (1967–1990).
Pick your Chevrolet P20 model year
- 1967
- 1971
- 1973
- 1974
- 1975
- 1976
- 1977
- 1982
- 1984
- 1985
- 1987
- 1988
- 1989
- 1990
| Model year | Recalls | Complaints |
|---|---|---|
| 1990 Chevrolet P20 | 1 | 0 |
| 1989 Chevrolet P20 | 1 | 0 |
| 1988 Chevrolet P20 | 1 | 0 |
| 1987 Chevrolet P20 | 1 | 0 |
| 1985 Chevrolet P20 | 1 | 0 |
| 1984 Chevrolet P20 | 1 | 0 |
| 1982 Chevrolet P20 | 2 | 0 |
| 1977 Chevrolet P20 | 1 | 0 |
| 1976 Chevrolet P20 | 1 | 0 |
| 1975 Chevrolet P20 | 1 | 0 |
| 1974 Chevrolet P20 | 1 | 0 |
| 1973 Chevrolet P20 | 1 | 0 |
| 1971 Chevrolet P20 | 1 | 0 |
| 1967 Chevrolet P20 | 1 | 0 |
All Chevrolet P20 recalls (10)
Every NHTSA safety campaign that lists a Chevrolet P20, most recent first, with the model years each one covers.
-
Seats
Seat pedestals for driver and passengers may have a larger than specified slot in the center channel.
Remedy: Replace seat pedestals with pedestals having proper slot size.
Model years: 1987, 1988, 1989, 1990
-
Seats
Three bolts which attach the sill that supports the base of the seat were omitted; therefore vehicles do not comply with FMVSS 210 and FMVSS 207. Consequence of defect: in the event of a crash, the floor plate could buckle along the inboard side causing the seat pedestal to be imbalanced, and increasing the likelihood of injury to the…
Remedy: Install missing bolts.
Model years: 1984, 1985
-
Filler pipe and cap (fuel system)
In a vehicle impact from the rear, the three piece hoses could separate and result in fuel leakage in excess of the amount permitted by federal motor vehicle safety standard no. 301, "fuel system integrity".
Remedy: A new fuel filler hose will be installed by dealer on all involved vehicles.
Model years: 1982
-
Axle shaft (power train)
The rear axle shafts received improper heat treatment during manufacture. The shaft may break and the tire and wheel assembly could disengage from the vehicle.
Remedy: Dealer will replace both rear axle shaft assemblies, if necessary, free of charge.
Model years: 1982
-
Seats
The involved vehicles fail to comply with federal motor vehicle safety standard no. 207, "anchorage of seats", due to possible failure of the seat post attachment at the floor in the event of an accident. These vehicles have oversized bolt holes in the floor pan which may allow the seat attaching nuts to pass through them and thus…
Remedy: Dealer will install a steel reinforcement plate on the bottom surface of the longitudinal sill, at no cost to owner.
Model years: 1977
-
Suspension: lower arm
The front suspension control arms were assembled with ball joints which may contain sockets that were not properly heat-treated. This may cause the socket to wear rapidly and allow the ball joint stud to separate from the socket, causing either the left or right wheel suspension to collapse.
Remedy: Dealer will inspect and, where necessary, will replace the ball joints without charge to owner.
Model years: 1975, 1976
-
Suspension: upper arm
Model years: 1974
-
Pedals and linkages (service brakes)
Model years: 1973
-
Wheels
Model years: 1971
-
Hoses, lines/piping, and fittings (service brakes)
Model years: 1967
Other Chevrolet models
- Malibu19,364 complaints
- Silverado 150018,029 complaints
- Impala10,434 complaints
- Tahoe10,032 complaints
- Equinox9,161 complaints
- Silverado8,799 complaints
- Blazer8,192 complaints
- Suburban8,164 complaints
Source: NHTSA recall and complaint databases and EPA fuel economy data, October 2026. Complaint counts are owner reports to NHTSA, not verified defects. Recall counts are safety campaigns that list this model year; whether a particular car was already repaired depends on its VIN. How this data is compiled.