Chevrolet Lumina Apv Recalls & Complaints by Model Year
NHTSA lists 11 safety recalls and 478 owner complaints across 11 model years of the Chevrolet Lumina Apv (1987–1999). The most-complained-about year is 1995.
Pick your Chevrolet Lumina Apv model year
| Model year | Recalls | Complaints |
|---|---|---|
| 1999 Chevrolet Lumina Apv | 0 | 3 |
| 1998 Chevrolet Lumina Apv | 0 | 2 |
| 1997 Chevrolet Lumina Apv | 0 | 1 |
| 1996 Chevrolet Lumina Apv | 1 | 35 |
| 1995 Chevrolet Lumina Apv | 3 | 104 |
| 1994 Chevrolet Lumina Apv | 4 | 65 |
| 1993 Chevrolet Lumina Apv | 3 | 45 |
| 1992 Chevrolet Lumina Apv | 2 | 76 |
| 1991 Chevrolet Lumina Apv | 1 | 47 |
| 1990 Chevrolet Lumina Apv | 3 | 99 |
| 1987 Chevrolet Lumina Apv | 0 | 1 |
What Chevrolet Lumina Apv owners complain about
Across all model years, owners have filed 478 complaints with NHTSA. The 1995 model year has the most, with 104.
All Chevrolet Lumina Apv recalls (11)
Every NHTSA safety campaign that lists a Chevrolet Lumina Apv, most recent first, with the model years each one covers.
-
Rack and pinion (steering)
Certain passenger vehicles and MINI vans have lower pinion bearings in the power rack and pinion assembly in which the retainer tabs were not crimped properly. These and some other retainers used in vehicles assembled between january 1, 1996 and october 31, 1997, could fail and permit the ball bearings to escape.
Remedy: Dealers will install a new lower pinion bearing unless inspect of the existing bearing indicates that replacement of the gear assembly is necessary. Owner notification began january 24, 2003. Owners who take their…
Model years: 1996
-
Structure
Vehicle description: passenger vehicles and MINI vans originally sold or currently registered in the following states: connecticut, illinois, indiana, maine, massachusetts, michigan, new hampshire, new jersey, new york, ohio, pennsylvania, rhode island, vermont and wisconsin. The rear cradle bolts pull through the retainers due to…
Remedy: Dealers will replace the rear cradle bolts and retainers.
Model years: 1990, 1991
-
Cooling unit and lines (power train)
Vehicle description: passenger vehicles manufactured from august 1991 through july 1995. The transmission oil cooler line can separate when the vehicle is operated in low temperatures in combination with high transmission loads.
Remedy: Dealers will replace the transmission oil cooler lines.
-
Vehicle speed control
These vehicles were assembled with throttle cable support brackets that could contact the throttle lever system and inhibit the throttle return. This does not meet the requirements of FMVSS no. 124, "accelerator control systems."
Remedy: Dealers will replace the throttle cable support bracket.
Model years: 1995
-
Pedals and linkages (service brakes)
Improperly manufactured brake pedal arm causes the brake pedal arm to fracture during braking.
Remedy: Dealers will replace all suspect brake pedal assemblies.
Model years: 1995
-
Webbing (seat belts)
The second row, right hand shoulder belt can become "pinched" between the seat and the door frame pillar trim. The shoulder belt may not retract properly, which does not comply with the requirements of FMVSS no. 208, "occupant crash protection." the 1994 vehicles have an optional integral (built in) childseat installed next to the power…
Remedy: Dealers will replace the door frame pillar trim panel with a redesigned trim panel. Also, a caution label will be applied to the child seat advising the owner not to install the seat to the passenger side of a vehicle…
-
Retractor (seat belts)
The third row safety belt retractors may be installed incorrectly and may lock-up when the vehicle is on slopes of less than 15 degrees, which does not comply with FMVSS no. 209, "seat belt assemblies."
Remedy: Dealers will remove third row safety belt retractors and reinstall them properly.
Model years: 1994
-
Seat belts: rear/other
Vehicle fails to conform to FMVSS no. 209, "seat belt assemblies." the safety belt of the left third row seat on the six passenger van and the center second row seat of the seven passenger van may lock up and cannot be withdrawn from the retractor.
Remedy: Owners are being asked to inspect their vehicles to determine if the suspect retractor exhibits a lockup condition. Based on this inspection, dealers will replace the safety belts if the belt locks up. Replacement of…
-
Seat belts: rear/other
The safety belt retractors for the rear center position are missing a pawl spring and in case of an accident, will allow the safety belt webbing to extend beyond the minimum requirements of FMVSS no. 208, "occupant crash protection."
Remedy: Dealers will inspect the safety belt retractor assembly and replace the retractor if the pawl spring is missing.
Model years: 1994
-
Anchorage (seat belts)
A right hand seat/shoulder belt retractor may have been installed in the second row left hand seat position (directly behind driver).
Remedy: Replace shoulder belt assembly.
Model years: 1990
-
Seats
The rear modular seat frame hold-down hooks may not meet the required pull force at the rear set anchorage.
Remedy: Replace rear hold down hooks and pivot rivets with heat treated hardware.
Model years: 1990
Other Chevrolet models
- Malibu19,364 complaints
- Silverado 150018,029 complaints
- Impala10,434 complaints
- Tahoe10,032 complaints
- Equinox9,161 complaints
- Silverado8,799 complaints
- Blazer8,192 complaints
- Suburban8,164 complaints
Source: NHTSA recall and complaint databases and EPA fuel economy data, October 2026. Complaint counts are owner reports to NHTSA, not verified defects. Recall counts are safety campaigns that list this model year; whether a particular car was already repaired depends on its VIN. How this data is compiled.