NHTSA Recall 06V483000: Structure
HINO MOTORS SALES U.S.A., INC. reported this safety recall to NHTSA on , covering an estimated 1,599 vehicles. It affects 4 models including the Hino ND8J.
| NHTSA campaign | 06V483000 |
|---|---|
| Manufacturer campaign | M0070 |
| Component | STRUCTURE |
| Report received | December 15, 2006 |
| Owner notification | December 4, 2006 |
| Initiated by | Manufacturer |
Defect
On certain vehicles, during the stamping process, some crossmembers were manufactured with a deformation to the lower corners due to excessive wear of the stamping die. Over time, if this condition were ignored, the structural integrity of the crossmembers could be compromised which could result in a loss of braking ability, separation of the propeller shaft and/or a loss of rear warning lamps.
Safety risk
Any of these occurrences could result in a crash.
Remedy
Dealers will inspect, correct, and replace the crossmembers. The recall began on december 4, 2006. Owners may contact hino at 1-248-648-6400.
Notes
Hino recall no. M0070.customers may also contact the national highway traffic safety administration's vehicle safety hotline at 1-888-327-4236 (tty 1-800-424-9153), or go to http://www.safercar.gov.
Vehicles covered by recall 06V483000
| Make and model | Model years |
|---|---|
| Hino ND8J | 2006, 2007 |
| Hino NE8J | 2006, 2007 |
| Hino NJ8J | 2006, 2007 |
| Hino NV8J | 2006, 2007 |
Being listed here means the campaign covers the model year, not that every car was built with the defect or is still unrepaired. Enter your VIN above to check your specific vehicle. Recall repairs are free at authorised dealers. Source: NHTSA, October 2026.