Plymouth Fury Recalls & Complaints by Model Year
NHTSA lists 45 safety recalls and 5 owner complaints across 19 model years of the Plymouth Fury (1967–1989). The most-complained-about year is 1978.
Pick your Plymouth Fury model year
| Model year | Recalls | Complaints |
|---|---|---|
| 1989 Plymouth Fury | 0 | 1 |
| 1988 Plymouth Fury | 1 | 1 |
| 1987 Plymouth Fury | 0 | 1 |
| 1986 Plymouth Fury | 1 | 0 |
| 1985 Plymouth Fury | 0 | 1 |
| 1982 Plymouth Fury | 2 | 0 |
| 1981 Plymouth Fury | 2 | 0 |
| 1978 Plymouth Fury | 2 | 1 |
| 1977 Plymouth Fury | 3 | 0 |
| 1976 Plymouth Fury | 2 | 0 |
| 1975 Plymouth Fury | 5 | 0 |
| 1974 Plymouth Fury | 5 | 0 |
| 1973 Plymouth Fury | 3 | 0 |
| 1972 Plymouth Fury | 8 | 0 |
| 1971 Plymouth Fury | 2 | 0 |
| 1970 Plymouth Fury | 1 | 0 |
| 1969 Plymouth Fury | 2 | 0 |
| 1968 Plymouth Fury | 4 | 0 |
| 1967 Plymouth Fury | 9 | 0 |
What Plymouth Fury owners complain about
Across all model years, owners have filed 5 complaints with NHTSA. The 1978 model year has the most, with 1.
All Plymouth Fury recalls (45)
Every NHTSA safety campaign that lists a Plymouth Fury, most recent first, with the model years each one covers.
-
Electrical system: front underhood
Engine compartment wiring harness fusible link wires may be trapped under the speed control servo bracket.
Remedy: Free any trapped wiring; then secure wiring with a tie strap to keep away from speed control bracket.
Model years: 1988
-
12v/24v/48v battery (electrical system)
Battery cap vents may be partially or completely blocked with plastic flashing. Consequence of defect: a build up of internal gas pressure could occur which could result in case rupture, particularly during post charging. Should a person be in the vicinity of the battery when the case ruptures, they may be injured by the released gases…
Remedy: Rework batteries by probing both vent orifices to eliminate any vent obstruction.
Model years: 1986
-
Manifold/header/muffler/tail pipe (engine and engine cooling)
Excessive heat may be transferred to the vehicle floor pan in the rear seat area. This occurs because the muffler heat shield was omitted during manufacture of certain fleet cars. Rear seat cushions may be scorched by heat.
Remedy: Heat sheilds are being sent directly to fleet owners, who may either install them personally or arrange for dealer installation.
Model years: 1982
-
Vehicle speed control
The automatic speed control switch may stick in the "resume" position restricting return movement. This will not allow the normal brake pedal operation to deactivate the system.
Remedy: The shield portion of the "resume" slide lever in the speed control unit will be replaced without charge.
Model years: 1981, 1982
-
Carburetor system (fuel system)
Engine may lose power or stall due to carburetor flooding. This is caused by a poor electrical ground on the carburetor fuel bowl vent solenoid. Vehicles may also have driveability problems while the engine is warming up in cold weather. These problems include engine missing, sags, and hesitation. This is caused by a sticking carburetor…
Remedy: Dealer will inspect carburetor and if necessary, the bowl vent solenoid will be repaired by resoldering (reconnecting) the external electrical connection free of charge. If applicable, the oxygen feedback sensor will…
Model years: 1981
-
Carburetor system (fuel system)
When the accelerator pedal on the involved vehicles is depressed and the accelerator pump is activated, a distorted accelerator pump seal in the carburetor may prevent the pump from delivering the proper amount of fuel.
Remedy: Dealer will replace the carburetor accelerator pump seal with a seal of improved distortion resistance. The carburetor will also be checked for the proper float level.
-
Steering wheel/handle bar (steering)
The columns may contain steering shafts in which the steering column coupling roll pin retaining notch was machined too deep. This may cause the steering wheel shaft to become disengaged from the rest of the steering assembly.
Remedy: Dealer will install a cotter pin through the roll pin to ensure retention, at no cost to owner.
Model years: 1978
-
Electrical system: wiring
An interruption of the main electrical power feed circuit from the battery and alternator may occur due to separation of a terminal connection in the wiring circuit. The terminal end of the power feed wire coming from the compartment may separate from its mating terminal on the wire going into the passenger compartment at the multiple…
Remedy: Dealer will repair the engine compartment power feed circuit wire by installing an overlay wire routed around the bulkhead connector.
-
Automatic transmission (power train)
The plastic transmission shift linkage bushings installed on the involved vehicles may become heat damaged because they are located near the MINI-catalytic converter. This condition could alter the adjusted relationship of the transmission shift linkage, causing the transmission to be in a gear position other than that indicated by the…
Remedy: Dealer will replace the plastic bushings with steel bushings and install retaining clips to ensure that shift rod is securely engaged to the linkage system.
Model years: 1977
-
Shoes/linings (service brakes)
Incorrect rear brake linings were installed on the involved vehicles. This does not comply with federal motor vehicle safety standard no. 105, "hydraulic brake systems". The existing brake linings could allow brake fluid to leak, causing partial loss of braking.
Remedy: Dealer will replace the rear brake lining with the proper lining, without charge.
Model years: 1978
-
Manifold/header/muffler/tail pipe (engine and engine cooling)
The required muffler to floor pan heat shields were omitted from the involved vehicles. These heat shields are necessary to protect the passenger compartment interior materials, including seat belt webbing, from heat damage.
Remedy: The dealer will install the necessary heat shields on all affected vehicles, free of charge.
Model years: 1977
-
Vacuum (service brakes)
Model years: 1976
-
Hose, piping, and connections (steering)
Model years: 1975
-
Suspension
Model years: 1975
-
Vacuum (service brakes)
-
Integrated jack/leveler/stabilizer (equipment) and accessory scissor/screw/bottle jack/lift (equipment)
Model years: 1975
-
Hoses, lines/piping, and fittings (service brakes)
Model years: 1974
-
Suspension: lower arm
Model years: 1974
-
Hoses, lines/piping, and fittings (service brakes)
Model years: 1974
-
Defroster/defogger/hvac system (visibility)
Model years: 1974
-
Delivery (fuel system)
-
Vehicle speed control
Model years: 1973
-
Caliper (service brakes)
Model years: 1972
-
Bumpers (structure)
Model years: 1972
-
Automatic transmission (power train)
Model years: 1972
-
Electrical system
Model years: 1972
-
Pads (service brakes)
Model years: 1972
-
Automatic transmission (power train)
Model years: 1972
-
Vehicle speed control
Model years: 1970, 1971
-
Disc (service brakes)
Model years: 1971
-
Seat belts: front
Model years: 1969
-
Cooling unit and lines (power train)
Model years: 1969
-
Steering wheel/handle bar (steering)
Model years: 1967
-
Bead (tires)
Model years: 1968
-
Vehicle speed control
Model years: 1968
-
Webbing (seat belts)
Model years: 1968
-
Driveshaft (power train)
Model years: 1968
-
Linkages (steering)
Model years: 1967
-
Mechanical (parking brake)
Model years: 1967
-
Filler pipe and cap (fuel system)
Model years: 1967
-
Disc (service brakes)
Model years: 1967
-
Vehicle speed control
Model years: 1967
-
Switch/wiring (visibility)
Model years: 1967
-
Carburetor system (fuel system)
Model years: 1967
-
Column shift (power train)
Model years: 1967
Other Plymouth models
- Voyager5,245 complaints
- Grand Voyager2,440 complaints
- Neon1,372 complaints
- Breeze667 complaints
- Acclaim426 complaints
- Sundance309 complaints
- Colt138 complaints
- Laser117 complaints
Source: NHTSA recall and complaint databases and EPA fuel economy data, October 2026. Complaint counts are owner reports to NHTSA, not verified defects. Recall counts are safety campaigns that list this model year; whether a particular car was already repaired depends on its VIN. How this data is compiled.