Oldsmobile Ciera Recalls & Complaints by Model Year
NHTSA lists 10 safety recalls and 281 owner complaints across 11 model years of the Oldsmobile Ciera (1983–1996). The most-complained-about year is 1996.
Pick your Oldsmobile Ciera model year
| Model year | Recalls | Complaints |
|---|---|---|
| 1996 Oldsmobile Ciera | 1 | 83 |
| 1995 Oldsmobile Ciera | 1 | 34 |
| 1994 Oldsmobile Ciera | 4 | 46 |
| 1990 Oldsmobile Ciera | 2 | 20 |
| 1989 Oldsmobile Ciera | 1 | 31 |
| 1988 Oldsmobile Ciera | 1 | 25 |
| 1987 Oldsmobile Ciera | 1 | 17 |
| 1986 Oldsmobile Ciera | 0 | 14 |
| 1985 Oldsmobile Ciera | 0 | 8 |
| 1984 Oldsmobile Ciera | 2 | 3 |
| 1983 Oldsmobile Ciera | 1 | 0 |
What Oldsmobile Ciera owners complain about
Across all model years, owners have filed 281 complaints with NHTSA. The 1996 model year has the most, with 83.
All Oldsmobile Ciera recalls (10)
Every NHTSA safety campaign that lists a Oldsmobile Ciera, most recent first, with the model years each one covers.
-
Anchorage (seat belts)
These vehicles were assembled with rear outboard safety belt anchorages that may not withstand the required load. This does not comply with FMVSS no.210, "seat belt assembly anchorages."
Remedy: Dealers will replace the existing anchor bolts with a new shoulder bolt and thread locking adhesive. Additionally, noise control patches will be applied at each anchorage.
-
Arm (steering)
The right hand spindle nut was not properly tightened during assembly. This can cause premature wheel bearing failure and over time, the spindle can fracture.
Remedy: Dealers will inspect the torque on the right hand front spindle nut. If the spindle nut is undertorqued the dealer will replace the right hand front wheel bearing assembly and the spindle nut will be replaced.
Model years: 1994
-
Latch (latches/locks/linkages)
Water intrusion can cause a short circuit in the power door lock assembly.
Remedy: Dealers will replace the power door lock relay and any corroded terminals. In addition, the new relay will be relocated to an area where water intrusion is less likely.
Model years: 1994
-
Springs (vehicle speed control)
In the event of a primary accelerator control spring failure, the secondary (back-up) accelerator control return spring will not return the throttle to the fully closed position, as required by FMVSS no. 124, "accelerator control system."
Remedy: Dealers will replace the secondary throttle return spring.
Model years: 1994
-
Recliner (seats)
The power seat or recliner wiring harness can be pinched or can chafe on the seat frame or spring support rod, wearing through the wire insulation and causing an electrical short.
Remedy: Repair any abraded wiring and reroute the wiring harness using a wiring harness clip.
Model years: 1990
-
Hoses, lines/piping, and fittings (fuel system)
Fuel feed hose could leak at the coupling on the engine end of the hose assembly.
Remedy: Install new fuel feed hose assembly.
Model years: 1988
-
Windshield (visibility)
Poor bond adhesion between the windshield glass and mounting could allow the windshield to separate during a 30 MPH frontal barrier test required by FMVSS 212.
Remedy: Reinstall windshields to assure proper bond adhesion.
Model years: 1987
-
Hoses, lines/piping, and fittings (fuel system)
The fuel system may leak at the throttle body injection fuel feed pipe connection. Consequence of defect: this leakage could result in an underhood fire which could spread to the passenger compartment and cause burn injuries to occupants.
Remedy: Replace the fuel feed pipe.
Model years: 1984
-
Recliner (seats)
Some vehicles have bucket seat back locks that do not conform to federal motor vehicle safety standard 207, anchorage of seats. In event of a crash, the seat back lock may not function.
Remedy: Inspection of seat back locks will be performed. Locks that have bent, broken or missing hooks will be replaced.
Model years: 1984
-
Differential proportional valve (service brakes)
The brake proportioner valves may break and separate from the master cylinder. This would allow brake fluid to leak and would result in a partial loss of the brake system.
Remedy: The dealer will inspect and, if necessary, replace all suspect valves.
Model years: 1983
Other Oldsmobile models
- Alero1,957 complaints
- Cutlass1,609 complaints
- Intrigue1,140 complaints
- Bravada962 complaints
- Silhouette950 complaints
- 88931 complaints
- Aurora786 complaints
- Achieva416 complaints
Source: NHTSA recall and complaint databases and EPA fuel economy data, October 2026. Complaint counts are owner reports to NHTSA, not verified defects. Recall counts are safety campaigns that list this model year; whether a particular car was already repaired depends on its VIN. How this data is compiled.