Mercury Mystique Recalls & Complaints by Model Year
NHTSA lists 19 safety recalls and 1,019 owner complaints across 9 model years of the Mercury Mystique (1994–2002). The most-complained-about year is 1995.
Pick your Mercury Mystique model year
| Model year | Recalls | Complaints |
|---|---|---|
| 2002 Mercury Mystique | 0 | 2 |
| 2001 Mercury Mystique | 0 | 2 |
| 2000 Mercury Mystique | 3 | 63 |
| 1999 Mercury Mystique | 2 | 128 |
| 1998 Mercury Mystique | 8 | 231 |
| 1997 Mercury Mystique | 4 | 71 |
| 1996 Mercury Mystique | 7 | 185 |
| 1995 Mercury Mystique | 8 | 335 |
| 1994 Mercury Mystique | 0 | 2 |
What Mercury Mystique owners complain about
Across all model years, owners have filed 1,019 complaints with NHTSA. The 1995 model year has the most, with 335.
All Mercury Mystique recalls (19)
Every NHTSA safety campaign that lists a Mercury Mystique, most recent first, with the model years each one covers.
-
Coil springs (suspension)
Vehicle description: passenger vehicles built at the kansas city assembly plant and originally sold in or currently registered in the states of connecticut, delaware, illinois, indiana, iowa, maine, maryland, massachusetts, michigan, minnesota, missouri, new hampshire, new jersey, new york, ohio, pennsylvania, rhode island, vermont,…
Remedy: Dealers will install spring catcher brackets. Owner notification began october 23, 2001. Owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a…
Model years: 1998
-
Electrical system
On certain my 1996-1998 passenger vehicles built at the kansas city, cuautitlan assembly plants or on my 1999 passenger vehcles built at the automotive alliance international assembly plants, the rough surface of the heater blower resistor's stainless steel blades can damage the copper surface of the wiring harness connector. The damage…
Remedy: Dealers will install a new heater blower resistor and a new wire jumper harness. Owner notification began august 29, 2001. Owners who take their vehicles to an authorized dealer on an agreed upon service date and do…
-
Engine and engine cooling
Vehicle description: 1995 passenger vehicles equipped with the 2.0l and 2.5l engines, and 1996 vehicles equipped with 2.5l engines. Tightening of the engine cooling fan motor bearings, up to and including motor stall, can result in increased motor torque and higher than normal motor current and accompanying high motor temperatures.
Remedy: Dealers will install a positive temperature coefficient device in-line with each fan motor. Ford will also extend the warranty on the engine cooling fan assembly to a total of 8 years of service or 100,000 miles from…
-
Seat belts
Vehicle description: passenger vehicles, light duty trucks, sport utility vehicles, and MINI vans equipped with trw seat belt buckle assemblies. The buckle base of these seat belt assemblies were not properly heat treated and therefore do not pass the load bearing requirement of federal motor vehicle safety standard no. 209, "seat belt…
Remedy: Dealers will inspect the date code on certain seat belt buckles of your vehicle and replace all seat belt buckles that fall within the suspect date code range. Owner notification began october 26, 2000. Owners who take…
Model years: 2000
-
Foundation components (service brakes)
Vehicle description: passenger vehicles not equipped with the anti-lock braking system (ABS). A pressure conscious reducing valve (pcrv) in the rear brakes may be subject to corrosion and result in malfunction, when operated in areas that use salt compounds on the roadway for de-icing or dust control.
Remedy: Dealers will install improved pcrv's in the rear brake system. This recall was expanded in september 2000 to include 1999 and 2000 ford contour, mercury mystique and cougar vehicles.
-
Labels (equipment)
Vehicle description: passenger vehicles. An incorrect label was installed on the driver side rear door. This label contains instructions for the activation of the childproof safety locks.
Remedy: Owners will be provided with a replacement label and installation instructions.
Model years: 2000
-
Filler pipe and cap (fuel system)
Vehicle description: passenger vehicles. The fuel filler pipe vent hose may have less than the intended level of ozone resistance, which could result in the hose becoming brittle and cracking.
Remedy: Dealers will install a fuel filler vent hose contacting the appropriate blend of pvc and nitrile rubber.
Model years: 1996
-
Air bags: sensor/control module-inactive
Vehicle description: passenger vehicles. The air bag sensor wiring pigtail insulation can become brittle and crack over time due to accumulation of water in the pigtail protective convolute in combination with high underhood temperatures related to the routing of the wiring pigtail near the radiator. This can result in environmental…
Remedy: Dealers will install air bag sensors with revised wiring insulation. In addition, vehicles which have the air bag warning light illuminated will have a new air bag diagnostic monitor installed.
Model years: 1998
-
Vehicle speed control
Vehicle description: passenger vehicles. The accelerator cable may have been manufactured with a burr on or near the end of the cable sleeve interior. This burr could fray the core wire resulting in the accelerator not returning to idle when the accelerator is released.
Remedy: Dealers will install a revised accelerator cable that has a flared conduit sleeve end and molded on end fitting.
Model years: 1998
-
Switch (exterior lighting)
Vehicle description: passenger vehicles. The terminals at the headlight switch and wiring harness connector can experience heat damage as a result of overheating.
Remedy: Dealers will install a headlamp switch wiring connector containing bronze terminals and an inspection, and replacement if necessary, of the headlamp switch.
-
Switch (electrical system)
Vehicle description: passenger vehicles built with automatic transmissions which utilize a park/lock solenoid. It is possible to rotate the ignition key to the lock position and remove the key without the shift lever and transmission being in park. These vehicles do not comply with the requirements of FMVSS no. 114, "theft protection."
Remedy: Dealers will inspect these vehicles. Vehicles that have units with ignition keys removable in gear positions other than park, will have the steering column replaced.
Model years: 1999
-
Floor shift (power train)
Vehicle description: passenger vehicles. The floor shift automatic transmission control can be damaged if subjected to certain interior cleaning products. The gear position indicator can deteriorate and not correctly indicate the actual gear position.
Remedy: Dealers will replace the automatic transmission floor shift control.
-
Headlights (exterior lighting)
Vehicle description: passenger vehicles. The text and/or graphics for the vehicle headlamp aiming instructions provided in the owner guides are not sufficiently clear. This does not meet the requirements of FMVSS no. 108, "lamps, reflective devices, and associated equipment."
Remedy: Owner guides containing revised aiming instructions will be mailed to owners of these vehicles.
Model years: 1998
-
Cables (vehicle speed control)
Vehicle description: passenger vehicles equipped with the traction control option. The throttle cables were damaged during vehicle assembly leading to fraying or separation of the throttle cable.
Remedy: Dealers will replace the throttle cable with a revised design that is less susceptible to bending or kinking during installation.
-
Filler pipe and cap (fuel system)
The fuel tank filler pipe opening reinforcement, constructed from two separately molded pieces, can leak at the weld.
Remedy: Dealers will replace the fuel tank assemblies with units containing one-piece molded reinforcements.
Model years: 1995
-
Anchorage (seat belts)
Cracks have been found in the front safety belt outboard anchor tabs due to a combination of hydrogen embrittlement of the tab and stress introduced during attachment of the anchor tab to the seat frame. This does not conform with the requirements of FMVSS no. 210, "seat belt assembly anchorages."
Remedy: Dealers will inspect and install an anchor tab reinforcement or replacement of the complete front seat belt assembly if an anchor tab is found to have fractured.
Model years: 1995
-
Windshield (visibility)
The glass tempering process on the right hand rear door windows was not correctly performed. This does not meet the requirements of FMVSS no. 205, "glazing materials."
Remedy: Dealers will replace the right rear door glass.
Model years: 1995
-
Filler pipe and cap (fuel system)
The fuel tank filler pipe opening reinforcement can leak at the weld.
Remedy: Dealers will inspect and, as appropriate, replace the fuel tanks.
Model years: 1995
-
Filler pipe and cap (fuel system)
A metal shield on the outside of the plastic fuel filler pipe can develop a static electrical charge during refueling of the vehicle.
Remedy: Dealers will inspect and, if necessary, modify the vehicles by adding a ground strap between the filler pipe shield and the body.
Model years: 1995
Other Mercury models
- Sable5,381 complaints
- Grand Marquis3,951 complaints
- Milan2,519 complaints
- Mountaineer1,992 complaints
- Cougar1,893 complaints
- Villager1,725 complaints
- Mariner1,296 complaints
- Tracer567 complaints
Source: NHTSA recall and complaint databases and EPA fuel economy data, October 2026. Complaint counts are owner reports to NHTSA, not verified defects. Recall counts are safety campaigns that list this model year; whether a particular car was already repaired depends on its VIN. How this data is compiled.