GMC G35 Recalls & Complaints by Model Year
NHTSA lists 14 safety recalls and 8 owner complaints across 14 model years of the GMC G35 (1973–2000). The most-complained-about year is 1995.
Pick your GMC G35 model year
| Model year | Recalls | Complaints |
|---|---|---|
| 2000 GMC G35 | 0 | 1 |
| 1996 GMC G35 | 3 | 1 |
| 1995 GMC G35 | 2 | 2 |
| 1994 GMC G35 | 0 | 1 |
| 1993 GMC G35 | 1 | 1 |
| 1992 GMC G35 | 3 | 0 |
| 1991 GMC G35 | 1 | 1 |
| 1990 GMC G35 | 1 | 1 |
| 1989 GMC G35 | 1 | 0 |
| 1987 GMC G35 | 1 | 0 |
| 1986 GMC G35 | 2 | 0 |
| 1985 GMC G35 | 1 | 0 |
| 1984 GMC G35 | 2 | 0 |
| 1973 GMC G35 | 1 | 0 |
What GMC G35 owners complain about
Across all model years, owners have filed 8 complaints with NHTSA. The 1995 model year has the most, with 2.
All GMC G35 recalls (14)
Every NHTSA safety campaign that lists a GMC G35, most recent first, with the model years each one covers.
-
Fuses and circuit breakers (electrical system)
Water intrusion into the kick panel areas in front of both the driver and passenger doors can cause a corrosion path between the battery feed and the electrical ground.
Remedy: Dealers will replace the 25 amp circuit breakers with 25 amp fuses in the fuse block; remove a temporary paper fuse-block cover; install a plastic shield over the fuse block; replace and reorient the power door lock…
Model years: 1996
-
Linkages (steering)
The steering linkage assemby contains a relay rod tapered-stud attachment nut that was not torqued to proper specifications.
Remedy: Dealers will remove the existing crimped nut and install a new nut torqued to specifications.
Model years: 1996
-
Bead (tires)
These tires have bead damage which occured during tire mounting.
Remedy: Dealers will demount each tire and inspect for bead damage. If bead damage is found, the tire will be replaced.
Model years: 1995, 1996
-
Cooling unit and lines (power train)
Due to a thin case casting, an external transmission leak can occur.
Remedy: Dealers will inspect the transmission case assembly for the involved case casting. If the assembly is involved, the transmission will be replaced.
Model years: 1995
-
Suspension: lower arm
The lower control arm can crack at the flange on the end of the control arm near the ball joint pad.
Remedy: Dealers will install a reinforcement brace on each of the front lower control arms.
Model years: 1992, 1993
-
Power assist (service brakes)
The brake pedal assembly has a pushrod pin that is too small and it is installed in the wrong position, causing an increased brake pedal ratio and a decreased master cylinder stroke.
Remedy: Replace the brake assembly.
Model years: 1992
-
Glass, side/rear (visibility)
Vehicles were incorrectly equipped with standard rear windows instead of the necessary riveted installation seal assemblies.
Remedy: Replace the existing rear window seals with the riveted installation seal assemblies.
Model years: 1992
-
Suspension: lower arm
The left hand lower control arm can crack starting at the rear flange and progressing to the ball joint mounting hole and eventually cause the lower ball joint to separate from the control arm.
Remedy: Install a resinforced brace to the left hand lower control arm.
Model years: 1985, 1986
-
Seats
Seat back of the rear bench seat may break away from the seat cushion in an accident.
Remedy: Install reinforcement that runs from side of seat back frame assembly to seat cushion frame assembly, strengthening the seat back.
Model years: 1989, 1990, 1991
-
Filler pipe and cap (fuel system)
Fuel tank lower filler pipe may contain small holes at some spot welds used to attach a mounting bracket.
Remedy: Replace fuel tank lower filler pipe.
Model years: 1987
-
Switch (exterior lighting)
The push pull headlight switch may have electrical contacts which allow an intermittent headlight circuit causing headlight to flicker or suddenly go out. Consequence of defect: sudden loss of the headlights under severe weather or nighttime driving conditions could reduce driver visibility which might result in a vehicle crash without…
Remedy: Replace headlight switch as necessary.
Model years: 1986
-
Filler pipe and cap (fuel system)
Due to a manufacturing problem with the fuel tank filler pipe, the fuel cap may improperly seal the end of the filler pipe. This fails to conform to the requirements of federal motor vehicle safety standard 301, "fuel system integrity." in the event of a collision, an improperly sealed filler pipe could allow fuel spillage.
Remedy: The dealer will inspect and replace fuel caps on all affected vehicles without charge.
Model years: 1984
-
Air conditioner (equipment)
Plastic plug located on top of the front air conditioner was not removed during assembly. This defect disrupts normal operation of evaporator blower housing.
Remedy: Rear a/c system blower will be inspected for damage such as melting or burning. If no damage is detected, the resistor will be replaced and any remaining pieces will be removed. If damage is detected, the resistor and…
Model years: 1984
-
Wheels
Model years: 1973
Other GMC models
- Sierra 15008,930 complaints
- Acadia5,569 complaints
- Yukon4,989 complaints
- Sierra3,937 complaints
- Terrain3,124 complaints
- Jimmy2,720 complaints
- Envoy2,459 complaints
- Yukon XL2,417 complaints
Source: NHTSA recall and complaint databases and EPA fuel economy data, October 2026. Complaint counts are owner reports to NHTSA, not verified defects. Recall counts are safety campaigns that list this model year; whether a particular car was already repaired depends on its VIN. How this data is compiled.