Dodge Dynasty Recalls & Complaints by Model Year
NHTSA lists 8 safety recalls and 462 owner complaints across 9 model years of the Dodge Dynasty (1988–1997). The most-complained-about year is 1992.
Pick your Dodge Dynasty model year
| Model year | Recalls | Complaints |
|---|---|---|
| 1997 Dodge Dynasty | 0 | 1 |
| 1995 Dodge Dynasty | 0 | 1 |
| 1994 Dodge Dynasty | 0 | 1 |
| 1993 Dodge Dynasty | 1 | 83 |
| 1992 Dodge Dynasty | 2 | 144 |
| 1991 Dodge Dynasty | 5 | 108 |
| 1990 Dodge Dynasty | 5 | 55 |
| 1989 Dodge Dynasty | 1 | 55 |
| 1988 Dodge Dynasty | 0 | 14 |
What Dodge Dynasty owners complain about
Across all model years, owners have filed 462 complaints with NHTSA. The 1992 model year has the most, with 144.
All Dodge Dynasty recalls (8)
Every NHTSA safety campaign that lists a Dodge Dynasty, most recent first, with the model years each one covers.
-
Antilock/traction control/electronic limited slip (service brakes)
The ABS hydraulic control unit can experience excessive brake actuator piston seal wear causing pump-motor deterioration.
Remedy: Dealers will test the vehicle's anti-lock brake system and repair the vehicles if necessary. Also the warranty on all ABS components will be extended to 10 years or 100,000 miles (except for the brake actuator piston…
-
Steering wheel/handle bar (steering)
The zinc plating operation performed on the upper steering column shaft coupling bolt caused hydrogen embrittlement and breakage of the bolt.
Remedy: Replace the zinc plated bolt with a phosphate plated bolt.
Model years: 1992
-
Hoses, lines/piping, and fittings (service brakes)
The anti-lock brake system high pressure hose may leak or detach at its crimped end fitting resulting in the discharge of hydraulic fluid.
Remedy: Replace the ABS high pressure hose with a hose of different design and construction.
-
Fan/motor (visibility)
Water leaking under windshield cowl in area above heater blower motor resistor block results in corrosion of the resistor terminals.
Remedy: The blower motor resistor block will be replaced, and a mastic patch applied to seal the cowl against water entry. Damaged wire connectors will be replaced.
-
Anchorage (seat belts)
Front outboard safety belt may become difficult to latch and or unlatch due to a webbing stiffener entering the buckle housing and dislodging the buckle latch guide.
Remedy: Replace buckle latch engagement.
Model years: 1991
-
Caliper (service brakes)
Front disc brake caliper guide pin bolts may not have been adequately torqued and could loosen.
Remedy: Properly torque front brake caliper guide pin bolts to 250 pounds.
Model years: 1991
-
Air bags: sensor/control module-inactive
Air bag inflator modules may not contain diffuser holes between the ignitor and propellant chambers.
Remedy: Replace air bag inflator modules with properly machined modules.
Model years: 1990
-
Engine (engine and engine cooling)
The engine valve cover gasket may dislocate and allow an engine oil leak at the gasket.
Remedy: Replace gasket cover with revised cover, and rtv sealant will be applied in place of a gasket.
Other Dodge models
- Durango13,770 complaints
- Grand Caravan13,508 complaints
- RAM 150012,416 complaints
- Caravan10,526 complaints
- Dakota6,629 complaints
- RAM 25006,443 complaints
- Intrepid6,228 complaints
- Charger5,741 complaints
Source: NHTSA recall and complaint databases and EPA fuel economy data, October 2026. Complaint counts are owner reports to NHTSA, not verified defects. Recall counts are safety campaigns that list this model year; whether a particular car was already repaired depends on its VIN. How this data is compiled.