RecallMyCar

Altec D3000 Recalls & Complaints by Model Year

NHTSA lists 3 safety recalls and 0 owner complaints across 6 model years of the Altec D3000 (2009–2021).

3
safety recalls, all years
0
owner complaints, all years
2010
year with most recalls

Pick your Altec D3000 model year

Model yearRecallsComplaints
2021 Altec D300010
2020 Altec D300010
2012 Altec D300010
2011 Altec D300010
2010 Altec D300020
2009 Altec D300010

All Altec D3000 recalls (3)

Every NHTSA safety campaign that lists a Altec D3000, most recent first, with the model years each one covers.

  1. Hoses/cables/rods/gears/strut/cylinder (equipment)

    NHTSA 21V512000 Reported 43 vehicles potentially affected Altec Industries, Inc.

    Altec Industries, Inc. (Altec) is recalling certain 2020-2021 D2000, 3000, and 4000 Derrick diggers. A retaining ring in the gearbox assembly was improperly seated during production, allowing the boom to unintentionally rotate freely.

    Remedy: Altec will repair the gearbox assembly, free of charge. Owner notification letters were mailed on September 3, 2021. Owners may contact Altec's customer service at 1-877-462-5832. Altec's number for this recall is CSN…

    Model years: 2020, 2021

  2. Winch (equipment)

    NHTSA 14V461000 Reported 67 vehicles potentially affected Altec Industries Inc.

    Altec Industries, Inc (Altec) is recalling certain model year 2010-2012 D2000 and D3000 boom tip winch digger derricks, equipped with winch units manufactured by Tulsa Winch Group (formerly Gear Products). The winch drum on the affected vehicles may deform or fracture.

    Remedy: Altec will notify owners and dealers will inspect and replace the winch drum if necessary, free of charge. The recall is expected to begin in September 2014. Owners may contact Altec customer service at 1-877-462-5832.…

    Model years: 2010, 2011, 2012

  3. Equipment

    NHTSA 11V318000 Reported 56 vehicles potentially affected ALTEC INDUSTRIES INC.

    Altec is recalling certain model year 2009-2010 aerial devices and digger derricks utility vehicles manufactured from april 2009 through may 2010. The high strength fasteners that connect the boom turntable to the pedestal may fail due to stress corrosion cracking, which could cause the boom to fall.

    Remedy: Altec will replace the fasteners to correct this condition, free of charge. The safety recall began during june 2011. Owners may contact altec at 1-877-462-5832.

    Model years: 2009, 2010

Other Altec models

Source: NHTSA recall and complaint databases and EPA fuel economy data, October 2026. Complaint counts are owner reports to NHTSA, not verified defects. Recall counts are safety campaigns that list this model year; whether a particular car was already repaired depends on its VIN. How this data is compiled.