Altec AT200A Recalls & Complaints by Model Year
NHTSA lists 8 safety recalls and 3 owner complaints across 15 model years of the Altec AT200A (2006–2024). The most-complained-about year is 2018.
Pick your Altec AT200A model year
What Altec AT200A owners complain about
Across all model years, owners have filed 3 complaints with NHTSA. The 2018 model year has the most, with 3.
All Altec AT200A recalls (8)
Every NHTSA safety campaign that lists a Altec AT200A, most recent first, with the model years each one covers.
-
Labels (equipment) and coil springs (suspension)
Altec Industries, Inc. (Altec) is recalling certain 2017-2024 Ford E350 van chassis equipped with a AT200A devices. The units mounted on certain Ford E350 van chassis with Gross Axle Weight Rating (GAWR) of 4050 and 4200 pounds, may fail at high loads due to a defect in the front axle.
Remedy: Ford dealers will install front springs, insulators, and nuts, free of charge. Additionally, a new label will be provided to indicate the upgraded gross axle weight rating. Owner notification letters were mailed…
-
Electrical system
Altec Industries Inc. (Altec) is recalling certain 2016-2022 van mounted AT200A and AT30G vehicles. The ground-fault circuit interrupter (GFCI) outlet may not provide adequate circuit protection against an electrical overload condition.
Remedy: Altec will install a new GFCI outlet with a circuit-breaker and new wiring, free of charge. Owner notification letters are expected to be mailed August 29, 2022. Owners may contact Altec's customer service at…
-
Markings (tires)
Altec Industries Inc. (Altec) is recalling certain 2016-2018 AT200A vehicles built on Ford E-350 Cutaway chassis. The rear tire size and load rating may be incorrect, possibly resulting in the vehicle being overloaded.
Remedy: Altec will notify owners, and dealers will inspect the tires and replace any that are not the correct size and load rating, free of charge. The recall began May 22, 2020. Owners may contact Altec customer service at…
-
Equipment and exhaust system (engine and engine cooling)
Altec Industries, Inc. (Altec) is recalling certain model year 2010-2013 AT200A, AT235, AT235P, AT30-G, AT35-G, AT37-G, AT40-G and AT237 Aerial Devices mounted on Ford Super Duty Chassis' equipped with 6.8L gas engines and Muncie FR67 power take offs (PTO). In the affected vehicles, oil may leak from the PTO pressure switch onto a…
Remedy: Altec will notify owners, and dealers will replace the affected pressure switch and thermal blanket with the kit identified by Muncie, free of charge. The recall began on December 9, 2013. Consumerr's may contact Altec…
-
Cables (electrical system)
Altec Industries, Inc. is recalling certain model year 2010-2012 AT200A, AT235/235P, AT237, AT248F, AT35/37-G, and AT40-G aerial devices built on Ford F550 chassis with a gross vehicle weight rating of 19,500lbs. The battery cable going to the unit auxiliary functions could be damaged and possibly short to ground.
Remedy: Altec began notifying affected owners on April 24, 2013. Dealers will re-route the auxiliary function battery cables. Owners may contact Altec at 1-800-860-0183. Altec's recall number is CSN 565.
-
Torsion bar (suspension)
Altec Industries, Inc. is recalling certain model year 2012 Aerial Device vehicles built on a Navistar Terrastar chassis because the Altec-installed torsion bar increases the ride height of the front suspension, which when the vehicle hits bumps, may cause the vehicle to alter its steering direction.
Remedy: Altec will notify owners, and will install an updated bracket and spring kit, free of charge. The safety recall began on August 27, 2012. Owners may contact Altec Industries at 1-877-462-5832.
Model years: 2012
-
Equipment
Altec is recalling certain at35-g, at37-g, at235, and at237 aerial devices manufactured from january 2005 through october 2008. These units are equipped with billet steel counterweight that is welded in place. In the event of weld failure, the counterweight may fall out while travelling.
Remedy: Altec has developed kits to improve the attachment of the billet steel counterweights. Customers at their option may perform the repair or have a dealer install the kit free of charge. The safety recall is expected to…
-
Hose, piping, and connections (steering)
Altec is recalling certain model year 2006-2007 at200a, at235, model year 2007-2010 at235p and model year 2008 at3xg trucks built on GM chassis. There is a potential hydraulic hose routing condition in the engine compartment. The hose could contact and cause some abrasions to an oem 12v chassis wire or possibly rub on the steel power…
Remedy: Altec will provide instructions to dealers on how to inspect and install the new bracket free of charge. This service will be performed free of charge. The safety recall began on september 15, 2010. Owners may contact…
Other Altec models
- Aerial Device1 complaints
- 43000 complaints
- 470 Knuckle Boom Crane0 complaints
- 47000 complaints
- 49000 complaints
- 73000 complaints
- 74000 complaints
- A-Class0 complaints
Source: NHTSA recall and complaint databases and EPA fuel economy data, October 2026. Complaint counts are owner reports to NHTSA, not verified defects. Recall counts are safety campaigns that list this model year; whether a particular car was already repaired depends on its VIN. How this data is compiled.