NHTSA Recall 12V390000: Torsion bar (suspension)
ALTEC INDUSTRIES INC. reported this safety recall to NHTSA on , covering an estimated 141 vehicles. It affects 6 models including the Altec AT200A.
| NHTSA campaign | 12V390000 |
|---|---|
| Manufacturer campaign | CSN 560 |
| Component | SUSPENSION › FRONT › SPRINGS › TORSION BAR |
| Report received | August 8, 2012 |
| Owner notification | August 27, 2012 |
| Initiated by | Manufacturer |
Defect
Altec Industries, Inc. is recalling certain model year 2012 Aerial Device vehicles built on a Navistar Terrastar chassis because the Altec-installed torsion bar increases the ride height of the front suspension, which when the vehicle hits bumps, may cause the vehicle to alter its steering direction.
Safety risk
As the vehicle hits bumps, it may deviate from the intended line of travel, increasing the risk of a crash.
Remedy
Altec will notify owners, and will install an updated bracket and spring kit, free of charge. The safety recall began on August 27, 2012. Owners may contact Altec Industries at 1-877-462-5832.
Notes
Altec's recall campaign number is CSN 560.Customers may contact the National Highway Traffic Safety Administration's Vehicle Safety Hotline at 1-888-327-4236 (TTY: 1-800-424-9153); or go to http://www.safercar.gov.
Vehicles covered by recall 12V390000
| Make and model | Model years |
|---|---|
| Altec AT200A | 2012 |
| Altec AT235 | 2012 |
| Altec AT235P | 2012 |
| Altec AT30-G | 2012 |
| Altec AT37-G | 2012 |
| Altec AT40M/P | 2012 |
Being listed here means the campaign covers the model year, not that every car was built with the defect or is still unrepaired. Enter your VIN above to check your specific vehicle. Recall repairs are free at authorised dealers. Source: NHTSA, October 2026.