NHTSA Recall 76V067000: Cables (vehicle speed control)
FORD MOTOR COMPANY reported this safety recall to NHTSA on , covering an estimated 410,580 vehicles. It affects 13 models including the Ford Elite.
| NHTSA campaign | 76V067000 |
|---|---|
| Component | VEHICLE SPEED CONTROL › CABLES |
| Report received | April 29, 1976 |
| Owner notification | May 18, 1976 |
| Initiated by | Manufacturer |
Defect
Not provided.
Safety risk
Not provided.
Remedy
Not provided.
Notes
Ford campaign no 192. Possibility that the nylon bushing in the acceleratorncable may become loose due to an oversize retaining clip. A loose bushing maylrestrict the accelerator cable from returning to idle or to a lower speedor to a slower speed condition, holding carburetor at constant speed. Shouldthis occur, the driver can stop the vehicle by applying the brakes, shiftingto neutral and turning off the ignition. (correct by inspecting the bushingbushing retaining clip where necessary.)
Vehicles covered by recall 76V067000
| Make and model | Model years |
|---|---|
| Ford Elite | 1976 |
| Ford Granada | 1976 |
| Ford Maverick | 1976 |
| Ford Pinto | 1976 |
| Ford Ranchero | 1976 |
| Ford Thunderbird | 1976 |
| Ford Torino | 1976 |
| Lincoln Mark IV | 1976 |
| Mercury Bobcat | 1976 |
| Mercury Comet | 1976 |
| Mercury Cougar | 1976 |
| Mercury Monarch | 1976 |
| Mercury Montego | 1976 |
Being listed here means the campaign covers the model year, not that every car was built with the defect or is still unrepaired. Enter your VIN above to check your specific vehicle. Recall repairs are free at authorised dealers. Source: NHTSA, October 2026.