NHTSA Recall 24V881000: Hoses/cables/rods/gears/strut/cylinder (equipment)
Altec Industries, Inc. reported this safety recall to NHTSA on , covering an estimated 158 vehicles. It affects 2 models including the Altec Am.
| NHTSA campaign | 24V881000 |
|---|---|
| Manufacturer campaign | CSN-3199 |
| Component | EQUIPMENT › MECHANICAL › BOOM/CRANE/LADDER › HOSES/CABLES/RODS/GEARS/STRUT/CYLINDER |
| Report received | November 21, 2024 |
| Owner notification | January 15, 2025 |
| Initiated by | Manufacturer |
Defect
Altec Industries, Inc. (Altec) is recalling certain 1995-1996 AM and AN aerial devices. Please see the recall report for a complete list of models. The hydraulic cylinder head gland may have been improperly manufactured, which can result in it detaching from the barrel of the cylinder while under load, leaving the lower boom unsupported.
Safety risk
A loss of lower boom support during operation could cause the lower boom to fall, increasing the risk of injury.
Remedy
Owners should inspect the cylinder and confirm that the cylinder matches the part number and serial number list. If the unit has an affected cylinder, the owner should remove the unit from service or replace the cylinder. If an owner chooses to keep a recalled unit in service, Altec will offer a kit the owner can purchase, and install at their own expense. Owner notification letters were mailed May 6, 2025. Owners may contact Altec customer service at 1-877-462-5832. Altec's number for this recall is CSN-3199.
Notes
Owners may also contact the National Highway Traffic Safety Administration Vehicle Safety Hotline at 1-888-327-4236 (TTY 1-800-424-9153) or go to nhtsa.gov.
Vehicles covered by recall 24V881000
Being listed here means the campaign covers the model year, not that every car was built with the defect or is still unrepaired. Enter your VIN above to check your specific vehicle. Recall repairs are free at authorised dealers. Source: NHTSA, October 2026.