NHTSA Recall 24V252000: Arm (steering)
Terex Advance Mixer, Inc. reported this safety recall to NHTSA on , covering an estimated 12 vehicles. It affects 2023 Terex Advance Commander.
| NHTSA campaign | 24V252000 |
|---|---|
| Component | STEERING › LINKAGES › KNUCKLE › SPINDLE › ARM |
| Report received | April 4, 2024 |
| Owner notification | June 5, 2024 |
| Initiated by | NHTSA Office of Defects Investigation |
Defect
Terex Advance Mixer, Inc. (Terex) is recalling certain 2023 Commander vehicles equipped with Composilite SC20 Lift Axles. The bearing journals may not be fully seated in the steering knuckle assemblies, preventing the proper installation of the wheel end hub assemblies.
Safety risk
An improperly installed wheel end hub assembly can leak oil, causing the axle spindles to loosen or fracture, increasing the risk of a crash.
Remedy
Dealers will inspect and replace the steering knuckle assemblies as necessary, free of charge. Owner notification letters were mailed June 5, 2024. Owners may contact Terex customer service at 1-800-678-5961.
Notes
Owners may also contact the National Highway Traffic Safety Administration Vehicle Safety Hotline at 1-888-327-4236 (TTY 1-800-424-9153), or go to www.nhtsa.gov.
Vehicles covered by recall 24V252000
| Make and model | Model years |
|---|---|
| Terex Advance Commander | 2023 |
Being listed here means the campaign covers the model year, not that every car was built with the defect or is still unrepaired. Enter your VIN above to check your specific vehicle. Recall repairs are free at authorised dealers. Source: NHTSA, October 2026.