NHTSA Recall 24V043000: Arm (steering)
PACCAR Incorporated reported this safety recall to NHTSA on , covering an estimated 68 vehicles. It affects 8 models including the Kenworth T800.
| NHTSA campaign | 24V043000 |
|---|---|
| Manufacturer campaign | 24PBB and 24KWB |
| Component | STEERING › LINKAGES › KNUCKLE › SPINDLE › ARM |
| Report received | January 25, 2024 |
| Owner notification | February 23, 2024 |
| Initiated by | Manufacturer |
Defect
PACCAR Incorporated (PACCAR) is recalling certain 2024 Peterbilt 367, 389, 520, 567, and Kenworth T800, T880, W900, and W990 trucks. The bearing journals may not be fully seated in the steering knuckle assemblies, preventing the proper installation of the wheel end hub assemblies.
Safety risk
An improperly installed wheel end hub assembly can leak oil, causing the axle spindles to loosen or fracture and increasing the risk of a crash.
Remedy
Dealers will inspect and replace the steering knuckle assemblies as necessary, free of charge. Owner letters were mailed February 23, 2024. Owners may contact Peterbilt customer service at 1-940-591-4220 and/or Kenworth customer service at 1-425-828-5888. PACCAR's numbers for this recall are 24PBB and 24KWB.
Notes
Owners may also contact the National Highway Traffic Safety Administration Vehicle Safety Hotline at 1-888-327-4236 (TTY 1-800-424-9153), or go to www.nhtsa.gov.
Vehicles covered by recall 24V043000
| Make and model | Model years |
|---|---|
| Kenworth T800 | 2024 |
| Kenworth T880 | 2024 |
| Kenworth W900 | 2024 |
| Kenworth W990 | 2024 |
| Peterbilt 367 | 2024 |
| Peterbilt 389 | 2024 |
| Peterbilt 520 | 2024 |
| Peterbilt 567 | 2024 |
Being listed here means the campaign covers the model year, not that every car was built with the defect or is still unrepaired. Enter your VIN above to check your specific vehicle. Recall repairs are free at authorised dealers. Source: NHTSA, October 2026.