NHTSA Recall 20V182000: Engine
Do not drive Indian Motorcycle Company reported this safety recall to NHTSA on , covering an estimated 616 vehicles. It affects 2020 Indian Challenger.
| NHTSA campaign | 20V182000 |
|---|---|
| Manufacturer campaign | I-20-02 |
| Component | ENGINE |
| Report received | March 25, 2020 |
| Owner notification | April 9, 2020 |
| Initiated by | Manufacturer |
Defect
Indian Motorcycle Company (Indian) is recalling certain 2020 Challenger motorcycles. The engine output shaft bearing may not have been sufficiently lubricated during assembly, possibly resulting in bearing failure at very low mileage.
Safety risk
Engine output shaft bearing failure could cause a sudden loss of power, increasing the risk of a crash.
Remedy
Indian will notify owners, and dealers will lubricate the output shaft bearings on motorcycles with less than 50 miles on the odometer, free of charge. Motorcycles with greater than 50 miles will not require a repair, and can either be inspected by a dealer, or the owner can self-report the odometer reading directly to Indian. The recall began April 9, 2020. Owners may contact Indian customer service at 1-877-204-3697. Indian's number for this recall is I-20-02. Note: Owners with an odometer reading of less than 50 miles are advised to not operate their motorcycle until it is repaired.
Notes
Owners may also contact the National Highway Traffic Safety Administration Vehicle Safety Hotline at 1-888-327-4236 (TTY 1-800-424-9153), or go to www.safercar.gov.
Vehicles covered by recall 20V182000
| Make and model | Model years |
|---|---|
| Indian Challenger | 2020 |
Being listed here means the campaign covers the model year, not that every car was built with the defect or is still unrepaired. Enter your VIN above to check your specific vehicle. Recall repairs are free at authorised dealers. Source: NHTSA, October 2026.