NHTSA Recall 18V494000: Axle shaft (power train)
Chrysler (FCA US LLC) reported this safety recall to NHTSA on , covering an estimated 702 vehicles. It affects 2018 Jeep Cherokee.
| NHTSA campaign | 18V494000 |
|---|---|
| Manufacturer campaign | U78 |
| Component | POWER TRAIN › AXLE ASSEMBLY › AXLE SHAFT |
| Report received | July 26, 2018 |
| Owner notification | September 20, 2018 |
| Initiated by | Manufacturer |
Defect
Chrysler (FCA US LLC) is recalling certain 2018 Jeep Cherokee all-wheel-drive vehicles. The bearing cage for the right front halfshaft assembly may not have been properly heat treated, possibly resulting in the bearing cage breaking and a potential halfshaft assembly failure.
Safety risk
If the halfshaft bearing cage breaks, the halfshaft may not be able to transmit engine power, causing a loss of drive or it can allow the vehicle to move while in the "Park" position. Either condition may increase the risk of a crash.
Remedy
Chrysler will notify owners, and dealers will replace the front right halfshaft assemblies, free of charge. The recall began September 20, 2018. Owners may contact Chrysler customer service at 1-800-853-1403. Chrysler's number for this recall is U78.
Notes
Owners may also contact the National Highway Traffic Safety Administration Vehicle Safety Hotline at 1-888-327-4236 (TTY 1-800-424-9153), or go to www.safercar.gov.
Vehicles covered by recall 18V494000
| Make and model | Model years |
|---|---|
| Jeep Cherokee | 2018 |
Being listed here means the campaign covers the model year, not that every car was built with the defect or is still unrepaired. Enter your VIN above to check your specific vehicle. Recall repairs are free at authorised dealers. Source: NHTSA, October 2026.