NHTSA Recall 17V570000: Tie rod assembly (steering) and steering
Pierce Manufacturing reported this safety recall to NHTSA on , covering an estimated 56 vehicles. It affects 6 models including the Pierce Arrow XT.
| NHTSA campaign | 17V570000 |
|---|---|
| Components | STEERING › LINKAGES › TIE ROD ASSEMBLY; STEERING |
| Report received | September 14, 2017 |
| Owner notification | November 30, 2017 |
| Initiated by | Manufacturer |
Defect
Pierce Manufacturing (Pierce) is recalling certain 2015-2016 Arrow XT, Enforcer, Impel, Quantum, Saber, and Velocity vehicles, equipped with certain Spicer D-Series and E-Series steer axles. The castellated nut on the steer axles may not be properly torqued, allowing the tie rod to loosen.
Safety risk
If the tie rod loosens, it may disconnect from the steering knuckle, causing a complete loss of steering and increasing the risk of a crash.
Remedy
Pierce will notify owners, and dealers will inspect the torque of the castellated nut and tie rod, tightening it as necessary. If the tie rod stud and knuckle on units cannot be sufficiently torqued, the dealer will replace the knuckle and tie rod end assembly, free of charge. The recall began on November 30, 2017. Owners may contact Pierce customer service at 1-414-832-3000.
Notes
Owners may also contact the National Highway Traffic Safety Administration Vehicle Safety Hotline at 1-888-327-4236 (TTY 1-800-424-9153), or go to www.safercar.gov.
Vehicles covered by recall 17V570000
| Make and model | Model years |
|---|---|
| Pierce Arrow XT | 2015, 2016 |
| Pierce Enforcer | 2015, 2016 |
| Pierce Impel | 2015, 2016 |
| Pierce Quantum | 2015, 2016 |
| Pierce Saber | 2015, 2016 |
| Pierce Velocity | 2015, 2016 |
Being listed here means the campaign covers the model year, not that every car was built with the defect or is still unrepaired. Enter your VIN above to check your specific vehicle. Recall repairs are free at authorised dealers. Source: NHTSA, October 2026.