NHTSA Recall 17V565000: Axle shaft (power train)
Kimble Mixer reported this safety recall to NHTSA on , covering an estimated 1 vehicles. It affects 2014 Kimble Mixer Custom Chassis.
| NHTSA campaign | 17V565000 |
|---|---|
| Manufacturer campaign | 15E-065 |
| Component | POWER TRAIN › AXLE ASSEMBLY › AXLE SHAFT |
| Report received | September 14, 2017 |
| Owner notification | September 7, 2017 |
| Initiated by | NHTSA Office of Defects Investigation |
Defect
Kimble Mixer has recalled one model year 2014 Mixer Custom Chassis equipped with a Marmon-Herrington drive axle. The hex nuts were improperly torqued where the flange mounts to the yoke.
Safety risk
The loose hex nuts may allow the driveshaft to disconnect from the drive axle, resulting in a loss of propulsion and increasing the risk of a crash.
Remedy
The affected vehicle for this recall has been repaired, therefore, a notification letter will not be issued. Owners may contact Kimble Mixer customer service at 1-918-286-2424. Kimble Mixer's number for this recall is 15E-065.
Notes
Owners may also contact the National Highway Traffic Safety Administration Vehicle Safety Hotline at 1-888-327-4236 (TTY 1-800-424-9153), or go to www.safercar.gov.
Vehicles covered by recall 17V565000
| Make and model | Model years |
|---|---|
| Kimble Mixer Custom Chassis | 2014 |
Being listed here means the campaign covers the model year, not that every car was built with the defect or is still unrepaired. Enter your VIN above to check your specific vehicle. Recall repairs are free at authorised dealers. Source: NHTSA, October 2026.