NHTSA Recall 16V371000: Axle assembly (power train)
Terex Advance reported this safety recall to NHTSA on , covering an estimated 117 vehicles. It affects 3 models including the Terex Advance Mixer FD3000.
| NHTSA campaign | 16V371000 |
|---|---|
| Component | POWER TRAIN › AXLE ASSEMBLY |
| Report received | May 26, 2016 |
| Owner notification | July 15, 2016 |
| Initiated by | NHTSA Office of Defects Investigation |
Defect
Terex Advance (Terex) is recalling certain model year 2015-2016 Mixer FD3000, FD4000, and FD6000B vehicles manufactured August 1, 2014, to September 30, 2015, and equipped with drive axles manufactured by Marmon-Herrington. The affected axles may have hex nuts on the flange yoke that may not have been properly tightened.
Safety risk
If the hex nuts are not tightened to specification, the driveshaft may disconnect from the drive axle, resulting in a loss of propulsion and increasing the risk of a crash.
Remedy
Terex will notify owners and provide instructions to properly torque the bolts. The recall began on July 15, 2016. Owners may contact Terex customer service at 1-800-433-6691.
Notes
Owners may also contact the National Highway Traffic Safety Administration Vehicle Safety Hotline at 1-888-327-4236 (TTY 1-800-424-9153), or go to www.safercar.gov.
Vehicles covered by recall 16V371000
| Make and model | Model years |
|---|---|
| Terex Advance Mixer FD3000 | 2015, 2016 |
| Terex Advance Mixer FD4000 | 2015, 2016 |
| Terex Advance Mixer FD6000B | 2015, 2016 |
Being listed here means the campaign covers the model year, not that every car was built with the defect or is still unrepaired. Enter your VIN above to check your specific vehicle. Recall repairs are free at authorised dealers. Source: NHTSA, October 2026.