NHTSA Recall 15V310000: Driveshaft (power train)
PACCAR Incorporated reported this safety recall to NHTSA on , covering an estimated 30 vehicles. It affects 4 models including the Kenworth T660.
| NHTSA campaign | 15V310000 |
|---|---|
| Manufacturer campaign | 15KWJ and 515-H |
| Component | POWER TRAIN › DRIVELINE › DRIVESHAFT |
| Report received | May 26, 2015 |
| Owner notification | July 15, 2015 |
| Initiated by | Manufacturer |
Defect
PACCAR Incorporated (PACCAR) is recalling certain model year 2014 and 2015 Kenworth T660, T680, and T800 trucks manufactured January 29, 2013, to April 2, 2014, and 2013 Peterbilt 587 trucks manufactured on August 8, 2012. The affected trucks are built with a driveshaft that may not transmit power to the wheels due to weld failure from corrosion.
Safety risk
If the weld fails causing a loss of power to the rear wheels, the vehicle operator may be unable to move the vehicle, or may experience deceleration if the vehicle is in motion, increasing the risk of a vehicle crash.
Remedy
PACCAR will notify owners, and dealers will replace the defective driveshafts, free of charge. The recall began on July 15, 2015. Owners may contact Kenworth customer service at 1-425-828-5000, or Peterbilt customer service at 1-940-591-4000. PACCAR's number for this recall is 15KWJ and 515-H.
Notes
Owners may also contact the National Highway Traffic Safety Administration Vehicle Safety Hotline at 1-888-327-4236 (TTY 1-800-424-9153), or go to www.safercar.gov.
Vehicles covered by recall 15V310000
| Make and model | Model years |
|---|---|
| Kenworth T660 | 2014, 2015 |
| Kenworth T680 | 2014, 2015 |
| Kenworth T800 | 2014, 2015 |
| Peterbilt 587 | 2013 |
Being listed here means the campaign covers the model year, not that every car was built with the defect or is still unrepaired. Enter your VIN above to check your specific vehicle. Recall repairs are free at authorised dealers. Source: NHTSA, October 2026.