NHTSA Recall 15V196000: Axle assembly (power train)
PACCAR Incorporated reported this safety recall to NHTSA on , covering an estimated 24 vehicles. It affects 2 models including the Kenworth T680.
| NHTSA campaign | 15V196000 |
|---|---|
| Manufacturer campaign | 15KWB |
| Component | POWER TRAIN › AXLE ASSEMBLY |
| Report received | April 3, 2015 |
| Owner notification | May 29, 2015 |
| Initiated by | Manufacturer |
Defect
PACCAR Incorporated (PACCAR) is recalling certain model year 2015-2016 Kenworth T680 and T880 trucks manufactured November 17, 2014, to January 5, 2015. The affected vehicles are equipped with Meritor MT-40-14X rear drive axles that may circulate an inadequate amount of lubricant to the wheel end hub assembly.
Safety risk
Without adequate lubrication to the wheel end hub assembly, the bearings may fail prematurely, increasing the risk of a wheel-end fire or crash.
Remedy
Kenworth will notify owners, and dealers will replace the defective rear drive axle and inspect the wheel ends for damage, replacing them, as needed, free of charge. The recall began May 29, 2015. Owners may contact Kenworth customer service at 1-425-828-5000. PACCAR's number for this recall is 15KWB.
Notes
Owners may also contact the National Highway Traffic Safety Administration Vehicle Safety Hotline at 1-888-327-4236 (TTY 1-800-424-9153), or go to www.safercar.gov.
Vehicles covered by recall 15V196000
Being listed here means the campaign covers the model year, not that every car was built with the defect or is still unrepaired. Enter your VIN above to check your specific vehicle. Recall repairs are free at authorised dealers. Source: NHTSA, October 2026.