NHTSA Recall 14V328000: Equipment
Iowa Mold Tooling Co., Inc. reported this safety recall to NHTSA on , covering an estimated 21 vehicles. It affects 3 models including the Ford F-350 SD.
| NHTSA campaign | 14V328000 |
|---|---|
| Component | EQUIPMENT |
| Report received | June 13, 2014 |
| Owner notification | July 28, 2014 |
| Initiated by | NHTSA Office of Defects Investigation |
Defect
Iowa Mold Tooling Co., Inc. will notify owners and dealers to inspect the Muncie PTO pressure switch to determine if it is from the range of defective switches and if required, remove the pressure switch assembly and put a plug in the port where the PTO switch had been installed. This switch was never being utilized. This will be done free of charge. The recall is expected to begin in mid-July 2014. Owners may contact Iowa Mold Tooling Co., Inc. at 1-800-247-5958.
Safety risk
The leaking oil may soak into the thermal blanket covering the exhaust, which when combined with heat from exhaust, may result in an increased risk of fire.
Remedy
Iowa Mold Tooling Co., Inc. will notify owners, and dealers will install a new pressure switch kit that moves the switch away from the exhaust system, free of charge. The recall began on July 28, 2014. Owners may contact Iowa Mold Tooling Co., Inc. at 1-800-247-5958.
Notes
Owners may also contact the National Highway Traffic Safety Administration Vehicle Safety Hotline at 1-888-327-4236 (TTY 1-800-424-9153), or go to www.safercar.gov.
Vehicles covered by recall 14V328000
| Make and model | Model years |
|---|---|
| Ford F-350 SD | 2009, 2010, 2011, 2012, 2013, 2014 |
| Ford F-450 SD | 2009, 2010, 2011, 2012, 2013, 2014 |
| Ford F-550 SD | 2009, 2010, 2011, 2012, 2013, 2014 |
Being listed here means the campaign covers the model year, not that every car was built with the defect or is still unrepaired. Enter your VIN above to check your specific vehicle. Recall repairs are free at authorised dealers. Source: NHTSA, October 2026.