Skip to content

NHTSA Recall 11V606000: Latch (latches/locks/linkages) and door (structure)

UTILIMASTER CORPORATION reported this safety recall to NHTSA on , covering an estimated 9,861 vehicles. It affects 2 models including the Utilimaster Aeromaster.

9,861
vehicles potentially affected
2
models affected
2012
owners notified (November 16)
NHTSA campaign11V606000
ComponentsLATCHES/LOCKS/LINKAGES › DOORS › LATCH; STRUCTURE › BODY › DOOR
Report receivedJanuary 3, 2012
Owner notificationNovember 16, 2012
Initiated byManufacturer

Defect

Certain Utilimaster model year 2009 through 2011 Aeromaster and one model year 2011 Reach work trucks manufactured from September 1, 2009, through December 22, 2011, fail to comply with the requirements of Federal Motor Vehicle Safety Standard No. 206, "Door Locks and Door Retention Components."

Safety risk

Certain work trucks are not equipped with either a primary door latch system or a door latch system with a fully latched position and a door closure warning system as required by FMVSS 206. Without a door closure warning system, the driver may not be aware that the door is not fully latched. The door could partially open without warning and the driver may be at an increased risk of injuries in the event of a crash.

Remedy

Utilimaster will notify owners, and dealers will repair the vehicles free of charge. The safety recall began on November 16, 2012. Owners may contact Utilimaster at 1-800-582-3454.

Notes

Owners may also contact the National Highway Traffic Safety Administration Vehicle Safety Hotline at 1-888-327-4236 (TTY 1-800-424-9153), or go to www.safercar.gov.

Vehicles covered by recall 11V606000

Make and modelModel years
Utilimaster Aeromaster2009, 2010, 2011
Utilimaster Reach2011

Being listed here means the campaign covers the model year, not that every car was built with the defect or is still unrepaired. Enter your VIN above to check your specific vehicle. Recall repairs are free at authorised dealers. Source: NHTSA, October 2026.