NHTSA Recall 10V390000: Electrical system: wiring
WINNEBAGO INDUSTRIES, INC. reported this safety recall to NHTSA on , covering an estimated 99 vehicles. It affects 2 models including the Itasca Sunstar.
| NHTSA campaign | 10V390000 |
|---|---|
| Manufacturer campaign | 117 |
| Component | ELECTRICAL SYSTEM › WIRING |
| Report received | September 1, 2010 |
| Owner notification | September 30, 2010 |
| Initiated by | Manufacturer |
Defect
Winnebago is recalling certain model year 2011 vista and itasca sunstar motor homes manufactured from march 16, 2010 through august 12, 2010. These vehicles may have the potential for a cable that powers the slideout room to make contact with the driveshaft when the slideout is retracted.
Safety risk
If this cable makes contact with the driveshaft, it could wear the protective jacket and insulation off the cable exposing the conductors to the driveshaft and electrifying the chassis, which could result in personal injury or death.
Remedy
Dealers will install a driveshaft closeout panel between the chassis frame rails to protect and support the wire harness. This service will be performed free of charge. The safety recall began on september 30, 2010. Owners may contact winnebago at 1-800-537-1885.
Notes
Winnebago safety recall no. Is 117.owners may also contact the national highway traffic safety administration's vehicle safety hotline at 1-888-327-4236 (tty 1-800-424-9153), or go to <a href=http://www.safercar.gov>http://www.safercar.gov</a> .
Vehicles covered by recall 10V390000
Being listed here means the campaign covers the model year, not that every car was built with the defect or is still unrepaired. Enter your VIN above to check your specific vehicle. Recall repairs are free at authorised dealers. Source: NHTSA, October 2026.