NHTSA Recall 10V150000: Axle assembly (power train)
PACCAR INCORPORATED reported this safety recall to NHTSA on , covering an estimated 23 vehicles. It affects 2 models including the Kenworth T270.
| NHTSA campaign | 10V150000 |
|---|---|
| Manufacturer campaign | 10KWA |
| Component | POWER TRAIN › AXLE ASSEMBLY |
| Report received | April 15, 2010 |
| Owner notification | April 23, 2010 |
| Initiated by | Manufacturer |
Defect
Kenworth is recalling certain model year 2010 t270 and t370 trucks equipped with non-lms hubs. The spindle nut attaching the hub and bearing to the axle spindle (steer or drive) may have been over-torqued during the hub installation process.
Safety risk
An over-torque of the spindle nut may cause the bearing to seize, possibly resulting in the overheating of the wheel end. As a result, a wheel end fire may occur.
Remedy
Dealers will replace the bearings free of charge. The spindle and hub will be inspected for scoring and replaced if necessary. The safety recall began on april 23, 2010. Owners may contact kenworth at 425-828-5440.
Notes
Paccar recall no. 10kwa.owners may also contact the national highway traffic safety administration's vehicle safety hotline at 1-888-327-4236 (tty 1-800-424-9153), or go to <a href=http://www.safercar.gov>http://www.safercar.gov</a> .
Vehicles covered by recall 10V150000
Being listed here means the campaign covers the model year, not that every car was built with the defect or is still unrepaired. Enter your VIN above to check your specific vehicle. Recall repairs are free at authorised dealers. Source: NHTSA, October 2026.