NHTSA Recall 07V128000: Engine and engine cooling
HONDA (AMERICAN HONDA MOTOR CO.) reported this safety recall to NHTSA on , covering an estimated 8,020 vehicles. It affects 2007 Honda CMX250C.
| NHTSA campaign | 07V128000 |
|---|---|
| Component | ENGINE AND ENGINE COOLING |
| Report received | March 21, 2007 |
| Owner notification | March 30, 2007 |
| Initiated by | Manufacturer |
Defect
On certain motorcycles, the crankcase breather separator may be defected. During the molding process, the breather passage may have been blocked by a thin layer of the injected plastic material. This blockage will create a build-up of pressure inside the crankcase and may cause the left side engine seal to be pushed out of position and an oil leak will occur.
Safety risk
Oil leaking from the failed seal while riding can spray onto the rear tire or the road, increasing the risk of a crash.
Remedy
Dealers will replace the breather separator, free of charge. The recall began on march 30, 2007. Owners may contact honda at 1-800-999-1009.
Notes
Customers may contact the national highway traffic safety administration's vehicle safety hotline at 1-888-327-4236 (tty: 1-800-424-9153); or go to http://www.safercar.gov.
Vehicles covered by recall 07V128000
| Make and model | Model years |
|---|---|
| Honda CMX250C | 2007 |
Being listed here means the campaign covers the model year, not that every car was built with the defect or is still unrepaired. Enter your VIN above to check your specific vehicle. Recall repairs are free at authorised dealers. Source: NHTSA, October 2026.