NHTSA Recall 05V496000: Column (steering)
WINNEBAGO INDUSTRIES, INC. reported this safety recall to NHTSA on , covering an estimated 152 vehicles. It affects 4 models including the Itasca Ellipse.
| NHTSA campaign | 05V496000 |
|---|---|
| Manufacturer campaign | 98 |
| Component | STEERING › COLUMN |
| Report received | November 1, 2005 |
| Owner notification | November 4, 2005 |
| Initiated by | Manufacturer |
Defect
On certain motor homes, the cinch bolt, where the steering column connects to the intermediate shaft, was improperly tightened. This could result in the bolt threads being stripped, conceivably not providing a tight joint.
Safety risk
If the joint is loose, the intermediate shaft has the potential to slip off the spline shaft of the steering column causing loss of steering control. This could result in personal injury or vehicle and property damage.
Remedy
Dealers will inspect and replace the cinch bolt and nut. The recall began november 4, 2005. Owners may contact winnebago at 641-585-6939.
Notes
Winnebago recall no. 98.customers may also contact the national highway traffic safety administration's vehicle safety hotline at 888-327-4236 (tty 1-800-424-9153), or go to http://www.safercar.gov.
Vehicles covered by recall 05V496000
| Make and model | Model years |
|---|---|
| Itasca Ellipse | 2006 |
| Itasca Meridian | 2006 |
| Winnebago Journey | 2006 |
| Winnebago Tour | 2006 |
Being listed here means the campaign covers the model year, not that every car was built with the defect or is still unrepaired. Enter your VIN above to check your specific vehicle. Recall repairs are free at authorised dealers. Source: NHTSA, October 2026.