NHTSA Recall 04V084000: Service brakes, hydraulic
WORKHORSE CUSTOM CHASSIS reported this safety recall to NHTSA on , covering an estimated 10,235 vehicles. It affects 2 models including the Workhorse W20.
| NHTSA campaign | 04V084000 |
|---|---|
| Manufacturer campaign | 50401-C |
| Component | SERVICE BRAKES, HYDRAULIC |
| Report received | February 18, 2004 |
| Owner notification | August 1, 2004 |
| Initiated by | NHTSA Office of Defects Investigation |
Defect
On certain motorhome chassis equipped with bosch zops, the pads can drag on the rotor surface due to the pin slide.
Safety risk
A hang up or lock up may cause the calipers to over heat and not allow the driver to stop safely. This could cause overheating of the brake calipers which could result in a vehicle fire.
Remedy
Dealers will inspect, repair and replace according to the procedure developed by bosch (see campaign 03e064000). The recall began on august 1, 2004. Owners should contact workhorse at 1-877-294-6773.
Notes
Workhorse recall no. 50401-c.customer's can also contact the national highway traffic safety administration's auto safety hotline at 1-888-dash-2-DOT (1-888-327-4236).
Vehicles covered by recall 04V084000
Being listed here means the campaign covers the model year, not that every car was built with the defect or is still unrepaired. Enter your VIN above to check your specific vehicle. Recall repairs are free at authorised dealers. Source: NHTSA, October 2026.