Plymouth B300 Recalls & Complaints by Model Year
NHTSA lists 6 safety recalls and 0 owner complaints across 10 model years of the Plymouth B300 (1971–1980).
Pick your Plymouth B300 model year
- 1971
- 1972
- 1973
- 1974
- 1975
- 1976
- 1977
- 1978
- 1979
- 1980
| Model year | Recalls | Complaints |
|---|---|---|
| 1980 Plymouth B300 | 1 | 0 |
| 1979 Plymouth B300 | 2 | 0 |
| 1978 Plymouth B300 | 2 | 0 |
| 1977 Plymouth B300 | 2 | 0 |
| 1976 Plymouth B300 | 2 | 0 |
| 1975 Plymouth B300 | 2 | 0 |
| 1974 Plymouth B300 | 2 | 0 |
| 1973 Plymouth B300 | 2 | 0 |
| 1972 Plymouth B300 | 1 | 0 |
| 1971 Plymouth B300 | 1 | 0 |
All Plymouth B300 recalls (6)
Every NHTSA safety campaign that lists a Plymouth B300, most recent first, with the model years each one covers.
-
Caliper (service brakes)
Due to a combination of disc brake pad wear and turn stop wear on certain vehicles, there may be an increase in brake pedal travel and a reduction in front braking effectiveness following a full turn. Also, a frame crack could develop and could extend through all or most of the rail section.
Remedy: Upon inspection dealer will replace either the left or right turn stop bracket to correct the front brakes. If frame is cracked it will be welded and a rod reinforcement will be installed over the cracked area.
Model years: 1973, 1974, 1975, 1976, 1977
-
Hinge and attachments (structure)
The hinge and roller assemblies supporting the rear of the sliding side door may be subject to failure as a result of processing deficiencies in the aluminum hinge body.
Remedy: Upon inspection all aluminum hinge bodies will be replaced with sintered metal components.
Model years: 1980
-
Frame and members (structure)
The front rail extension may experience fatigue cracking near the area where the power steering gear attaches to the frame. If the crack progresses through most or all of the rail section, steering system free play accompanied by metallic rattle noise will be experienced.
Remedy: Affected vehicles will be weld repaired and a reinforcement rod will be installed over the cracked area.
Model years: 1971, 1972, 1973, 1974, 1975, 1976, 1977, 1978
-
Air conditioner (equipment)
Condensate water may accumulate in the air conditioning blower housing; there is a high probability that this water will cause the blower motor to fail. Blower motor failure would disable the air condtioning unit and there would be no way to defrost or defog the windshield.
Remedy: Dealer will drill a 1/4 inch drain hole in the bottom of the air conditioning blower housing to prevent water accumulation, without charge to owner.
Model years: 1979
-
Hoses, lines/piping, and fittings (service brakes)
The front brake hose routing may allow interference between the hoses and the tire and wheel assemblies during extreme turning angles.
Remedy: Dealer will replace both left and right front brake hoses and install a new brake hose support bracket to eliminate contact with tire/wheel.
Model years: 1978
-
Suspension: lower arm
Lower control arms may fracture in the area adjacent to the lower ball joint, resulting in separation of the ball joint from the arm.
Remedy: Dealer will increase the strength of both lower control arms by installing welded reinforcements.
Model years: 1979
Other Plymouth models
- Voyager5,245 complaints
- Grand Voyager2,440 complaints
- Neon1,372 complaints
- Breeze667 complaints
- Acclaim426 complaints
- Sundance309 complaints
- Colt138 complaints
- Laser117 complaints
Source: NHTSA recall and complaint databases and EPA fuel economy data, October 2026. Complaint counts are owner reports to NHTSA, not verified defects. Recall counts are safety campaigns that list this model year; whether a particular car was already repaired depends on its VIN. How this data is compiled.