International 7600 Recalls & Complaints by Model Year
NHTSA lists 16 safety recalls and 1 owner complaint across 11 model years of the International 7600 (2002–2016). The most-complained-about year is 2005.
Pick your International 7600 model year
What International 7600 owners complain about
Across all model years, owners have filed 1 complaint with NHTSA. The 2005 model year has the most, with 1.
All International 7600 recalls (16)
Every NHTSA safety campaign that lists a International 7600, most recent first, with the model years each one covers.
-
Software (electrical system) and service brakes, air: control unit/module
International Motors, LLC (International) is recalling certain 2016 7600, 2016-2023 Lonestar, 2018 8600, 2018-2023 LT, 2021-2026 MV, 2022-2023 RH, 2023-2026 HX, and 2025-2026 HV vehicles. Electrical noise and low signal to the power line carrier may cause the ECU to incorrectly process commands or stop working.
Remedy: International will work with Bendix to reprogram the ECU, free of charge. Owner notification letters were mailed January 19, 2026. Owners may contact International's customer service at 1-800-448-7825. International's…
Model years: 2016
-
12v/24v/48v battery (electrical system)
Navistar has notified NHTSA of a defect on certain model year 2008-2011 international trucks equipped with an optional jump start stud. Corrosion at the base of the stud may cause an electrical short between the stud and battery box.
Remedy: A final remedy has been established. Navistar will notify owners, and dealers will repair the vehicles by installing a new jump start stud. Repairs will be preformed free of charge. An interim action will involve the…
-
Engine and engine cooling
Navistar is recalling certain model year 2008 and 2010 emergency vehicles manufactured between june 12, 2007 and june 24, 2009, equipped with cummins isb cm2150, isc cm2150, isl cm2150, ism cm876, and isx cm871 model diesel engines. The vehicles may be designed with a hard wired, dash-mounted switch that enables the vehicle operator to…
Remedy: Cummins is conducting this campaign and will provide the remedy free of charge. Please see cummins defect report 09e-046. Owners may contact cummins at 1-800-343-7357.
-
Driveshaft (power train)
On certain trucks equipped with split shaft style power take off (pto), the bolts that attach the drive shaft flanges to the split shaft pto may loosen and allow the drive shaft to separate from the vehicle.
Remedy: Dealers will replace and properly tighten the split shaft pto flange mounting bolts free of charge. The recall began on october 30, 2007. Owners may contact international at 1-800-448-7825.
-
Diesel (engine and engine cooling)
On certain heavy duty class 8 trucks built with cummins ism c876 engines, the electronic control module fails to recognize inputs of the vehicle electronic control unit or from a driver actuated dash switch thereby increasing the risk of unintended (or unexpected) elevated exhaust temperatures.
Remedy: Cummins, in conjunction with international, will conduct the remedy campaign. Cummins will install new ECM software. Owners can contact cummins at 1-800-343-7357 or international at 1-800-448-7825.
-
Parking brake
On certain 6x4 or 6x6 trucks with air brakes or tractors with air brakes and equipped with bendix sr-7 spring brake modulating valves, the internal rubber check valve may leak causing a delay in the application of the spring brakes to park the vehicle after the operator pulls the dash valve button.
Remedy: International is working with bendix to repair these vehicles (please see 07e-037). Bendix will install a check valve repair kit for the affected sr-7 spring brake modulating valve free of charge. The recall began on…
-
Fuel system, diesel
On certain trucks equipped with davco fuel pro 382 heated fuel filters, when the key is in the 'on' position, the pre-heater, located in the fuel filter base, is energized.
Remedy: Dealers will inspect the fuel filters and fuel heaters and, if necessary, will replace the fuel heater. The recall began on may 11, 2007. Owners may contact international at 1-800-448-7825.
-
Suspension
On certain trucks equipped with chalmers rear suspensions, the adjustable torque rod end castings may be brittle. A brittle rod end casting may fracture without warning, causing the vehicles' rear axles to become misaligned.
Remedy: Dealers will inspect the vehicles to determine if they were manufactured with a suspect torque rod end. If a suspect torque rod end is found, the entire torque rod will be replaced. The recall began on october 6, 2006.…
Model years: 2007
-
Air (parking brake)
On certain trucks equipped with sr-7 bendix brake valves, the check valve inside the valve cavity may not properly set, causing internal air leakage. If the check valve does not properly seat, the resulting leakage can cause a delay in the application of the spring brakes to park the vehicle after operator pulls the dash valve button.
Remedy: Dealers will inspect the valves and replace it free of charge. The recall began on july 21, 2006. Owners may contact international at 1-800-448-7825.
Model years: 2007
-
Engine and engine cooling
On certain heavy duty trucks equipped with caterpillar diesel engines, the engine electrical ground cable that connects the engine block with the starter may be routed in a way that could cause chafing against the starter's positive battery cables.
Remedy: Dealers will inspect the engine ground cables for proper routing. If any chafing is found, the engine block ground cable will be replaced with a shorter (280mm) cable and any other damaged cables will be replaced and…
-
Axle assembly (power train)
On certain heavy duty truck/tractors equipped with arvinmeritor series 145 and 160 rear drive axles. The suspect rear drive axle's spindles may have been incorrectly heat treated. Such a condition lessens the overall structural integrity of the spindles and could result in its fracture.
Remedy: Dealers will inspect the suspect vehicles and if the spindles are found to have certain date codes, the axle will be replaced. The recall began on october 7, 2005. Owners may contact international at 1-800-448-7825.
Model years: 2006
-
Fifth wheel assembly (trailer hitches)
On certain vehicles equipped with air operated fifth wheel slides and an msva 7-pack accessory controller, the 7-pack can allow water to contaminate its circuit board. This could result in inadvertent operation of the fifth wheel slide control.
Remedy: Dealers will relocate the msva 7-pack to a less water intensive environment. A new msva 7-pack base, that has been improved to prevent water intrusion, and all air accessory solenoids will be installed free of charge.…
-
Structure
On certain trucks, the bolts that mount the front of the cab to the mounting brackets were not properly torqued at the manufacturing plant.
Remedy: As an interim action, dealers will properly tighten the existing cab mounting bolts and replace any missing bolts. As soon as parts are available, dealers will replace all sixteen bolts and tighten them properly. An…
-
Cables (electrical system)
On certain heavy duty trucks equipped with international dt530, cummins, or caterpillar i-6 engines, the positive battery cable between the batteries and the starter may rub against an electrical ground cable between the starter and frame rail.
Remedy: Dealers will inspect for any chafing. If there is no evidence of chafing, a saddle clamp will be installed. If there is evidence of chafing, the damaged cables will be replaced and the saddle clamp installed. The…
-
Buckle assembly (seat belts)
Certain trucks fail to comply with the requirements of federal motor vehicle safety standard no. 209, "seat belt assemblies." the seat belt latch failed a quality review.
Remedy: Dealers will replace the seat belt assemblies. Owner notification is began on june 11, 2004. Owners should contact international at 1-800-445-7825.
Model years: 2004
-
Parking brake
Certain trucks fail to comply with the requirements of federal motor vehicle safety standard no. 121, "air brake systems." a standard fitting was installed in place of a single check valve on the park brake relay valve.
Remedy: Dealers will install the check valve. Owner notification began on may 3, 2004. Owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a…
Model years: 2004
Other International models
- 430037 complaints
- Prostar35 complaints
- School Bus21 complaints
- International17 complaints
- Ce16 complaints
- LT16 complaints
- 440010 complaints
- 30007 complaints
Source: NHTSA recall and complaint databases and EPA fuel economy data, October 2026. Complaint counts are owner reports to NHTSA, not verified defects. Recall counts are safety campaigns that list this model year; whether a particular car was already repaired depends on its VIN. How this data is compiled.