International Harvester Fleetstar Series Recalls & Complaints by Model Year
NHTSA lists 12 safety recalls and 0 owner complaints across 9 model years of the International Harvester Fleetstar Series (1971–1979).
Pick your International Harvester Fleetstar Series model year
| Model year | Recalls | Complaints |
|---|---|---|
| 1979 International Harvester Fleetstar Series | 1 | 0 |
| 1978 International Harvester Fleetstar Series | 3 | 0 |
| 1977 International Harvester Fleetstar Series | 5 | 0 |
| 1976 International Harvester Fleetstar Series | 3 | 0 |
| 1975 International Harvester Fleetstar Series | 7 | 0 |
| 1974 International Harvester Fleetstar Series | 5 | 0 |
| 1973 International Harvester Fleetstar Series | 4 | 0 |
| 1972 International Harvester Fleetstar Series | 1 | 0 |
| 1971 International Harvester Fleetstar Series | 1 | 0 |
All International Harvester Fleetstar Series recalls (12)
Every NHTSA safety campaign that lists a International Harvester Fleetstar Series, most recent first, with the model years each one covers.
-
Labels (equipment)
The involved vehicles do not have the required certification labels stating correct tire and rim information. These vehicles do not conform to federal motor vehicle safety standard no. 120, "tire selection and rims for vehicles other than passenger cars".
Remedy: Dealer will inspect and replace incorrect labels free of charge.
-
Drum (service brakes)
As a result of severe shock and vibrations, the brake spiders on the involved vehicles may develop cracks near the camshaft mounting boss. The crack propagates across the spider until the camshaft boss is completely severed from the remainder of the spider. When the camshaft boss has completely severed, the s-cam, s-cam bracket, air…
Remedy: The dealer will replace the front brake spiders on all affected vehicles used in snow plow dump and refuse hauling applications. This will be done at no charge.
-
Multi piece (wheels)
A casting deficiency may allow wheels to develop cracks in the spokes between the hub cap mounting area and the rim clamp pocket. Continued usage can lead to the disengaging of the rim and tire from the vehicle.
Remedy: Wheels with casting defects will be replaced at no charge.
-
Multi piece (wheels)
The deficiency exists in the front axle forged aluminum hubs. The deficiency which is in the barrel section between the inner and outer bearing, may result in cracks which could lead to hub failure. When hub failure occurs, the separated hub is retained on the axle spindle by the wheel bearing and adjusting nut.
Remedy: The dealer will replace the forged aluminum hubs with steel hubs, at no charge.
-
Hoses, lines/piping, and fittings (service brakes)
On the involved vehicles, the hose used to supply vacuum to the brake power unit or vacuum reserve tank may have been of the wrong material. This hose could deform sufficiently during normal operation to cause a reduction in vacuum assist to the brake power unit. This would result in greater brake pedal effort by operator and an…
Remedy: The dealer will inspect and, if necessary, remove incorrect hose and install the proper vacuum hose.
-
Linkages (steering)
-
Hoses, lines/piping, and fittings (service brakes)
Model years: 1975
-
Service brakes, air: control unit/module
-
Automatic transmission (power train)
-
Drum (service brakes)
Model years: 1975
-
Banjo housing (power train)
-
Hubcap/cover (wheels)
Other International Harvester models
- School Bus42 complaints
- 380041 complaints
- 470040 complaints
- 490021 complaints
- International Harvester11 complaints
- Conventional10 complaints
- 94008 complaints
- 93007 complaints
Source: NHTSA recall and complaint databases and EPA fuel economy data, October 2026. Complaint counts are owner reports to NHTSA, not verified defects. Recall counts are safety campaigns that list this model year; whether a particular car was already repaired depends on its VIN. How this data is compiled.