RecallMyCar

International Harvester 8200 Recalls & Complaints by Model Year

NHTSA lists 4 safety recalls and 0 owner complaints across 4 model years of the International Harvester 8200 (1994–1997).

4
safety recalls, all years
0
owner complaints, all years
1995
year with most recalls

Pick your International Harvester 8200 model year

Model yearRecallsComplaints
1997 International Harvester 820020
1996 International Harvester 820010
1995 International Harvester 820020
1994 International Harvester 820010

All International Harvester 8200 recalls (4)

Every NHTSA safety campaign that lists a International Harvester 8200, most recent first, with the model years each one covers.

  1. Suspension: rear

    NHTSA 96V240000 Reported 233 vehicles potentially affected INTERNATIONAL TRUCK AND ENGINE

    Vehicle description: school buses and heavy duty trucks equipped with rear axle assemblies produced by dana spicer. Certain rear axle assemblies were improperly heat treated which could allow pinion breakage at the pinion threads.

    Remedy: Dealers will replace the rear axle carrier/pinion assembly.

    Model years: 1997

  2. Suspension: rear

    NHTSA 96V233002 Reported 1,133 vehicles potentially affected INTERNATIONAL TRUCK AND ENGINE

    The drive axle housings consist of a plate steel center section and two forged spindles, one of which is welded to each end of the center section. Each spindle contains a keyway slot in which the locking tab for the wheel bearing nut locking mechanism is inserted. The length of the keyway slot may not be long enough to accommodate the…

    Remedy: Dealers will replace the drive axle housing nuts with a conventional wheel nut hardware system.

    Model years: 1997

  3. Hoses, lines/piping, and fittings (service brakes)

    NHTSA 95V144000 Reported 278 vehicles potentially affected INTERNATIONAL TRUCK AND ENGINE

    These vehicles were built with an improperly plumbed brake system which affects the braking on the rear axle when running either bobtail or pulling a trailer.

    Remedy: Navistar dealers will inspect vehicles and repair by installing brake lines and fittings as required.

    Model years: 1995, 1996

  4. Accelerator pedal (vehicle speed control)

    NHTSA 94V196000 Reported 6,449 vehicles potentially affected INTERNATIONAL TRUCK AND ENGINE

    The base of the electronic accelerator pedal is made of die cast aluminum. The base mounts directly to the cab firewall. The cab firewall is not rigid enough or flat enough at the mounting surface, causing stress on the accelerator base that will cause the mounting pads on the base of the pedal assembly to fail and totally separate from…

    Remedy: Dealers will inspect the accelerator pedal assembly and install a plate between the accelerator mounting base and the firewall on those units where the base is not broken and has no visible signs of a crack. If the…

    Model years: 1994, 1995

Other International Harvester models

Source: NHTSA recall and complaint databases and EPA fuel economy data, October 2026. Complaint counts are owner reports to NHTSA, not verified defects. Recall counts are safety campaigns that list this model year; whether a particular car was already repaired depends on its VIN. How this data is compiled.