Crane Coe Recalls & Complaints by Model Year
NHTSA lists 7 safety recalls and 0 owner complaints across 16 model years of the Crane Coe (1996–2015).
Pick your Crane Coe model year
| Model year | Recalls | Complaints |
|---|---|---|
| 2015 Crane Coe | 1 | 0 |
| 2014 Crane Coe | 2 | 0 |
| 2013 Crane Coe | 2 | 0 |
| 2012 Crane Coe | 2 | 0 |
| 2011 Crane Coe | 2 | 0 |
| 2010 Crane Coe | 2 | 0 |
| 2009 Crane Coe | 2 | 0 |
| 2008 Crane Coe | 2 | 0 |
| 2003 Crane Coe | 1 | 0 |
| 2002 Crane Coe | 2 | 0 |
| 2001 Crane Coe | 3 | 0 |
| 2000 Crane Coe | 3 | 0 |
| 1999 Crane Coe | 2 | 0 |
| 1998 Crane Coe | 1 | 0 |
| 1997 Crane Coe | 3 | 0 |
| 1996 Crane Coe | 1 | 0 |
All Crane Coe recalls (7)
Every NHTSA safety campaign that lists a Crane Coe, most recent first, with the model years each one covers.
-
Engine (engine and engine cooling)
Crane Carrier Company (Crane Carrier) is recalling certain model year 2008-2015 COE, LDT2, and LET2 trucks manufactured February 25, 2008, to May 20, 2015, and equipped with certain Cummins Westport ISL G engines. Excessive engine crankcase pressures may cause the 90-degree elbow of the vent tube assembly to detach from the crankcase…
Remedy: Cummins will notify owners on behalf of Crane Carrier, and dealers will secure the ends of the 90-degree elbow. In addition, the electronic control module (ECM) will be reprogrammed with software that can adjust the…
-
Engine (engine and engine cooling)
Crane Carrier Company (Crane) is recalling certain model year 2008-2014 LET2, COE, LDT2, and LE2 refuse vehicles manufactured April 16, 2008, through February 28, 2014, and equipped with certain Cummins Westport Model ISL G engines. Condensation in the intake manifold may freeze during cold weather conditions and interfere with the…
Remedy: Cummins Inc. and Cummins Wesport Inc. will notify owners, and authorized Cummins service facilities will upload a new ECM calibration, free of charge. The manufacturer has not yet provided a notification schedule.…
-
Service brakes, air
Crane carrier is recalling 672 my 1999-2001 coe,my 1999-2002 ldt, my 2001-2007 ldt2, my 1998-2003 let, and my 2001-2007 let2 refuse cab and chassis for failing to comply with the brake release timing requirements of federal motor vehicle safety standard no. 121, "air brake systems." the brake release timing was slower than required.
Remedy: Crane will replace several fittings and hoses which will increase the air flow and subsequently improve the brake release timing. The recall began on march 14, 2008. Owners may contact crane carrier at 918-832-7305.
-
Pressure relief devices (fuel system)
Certain trucks equipped with nexgen liquid natural gas (lng) tanks are being recalled. The introduction of water into the discharge side of both the primary and secondary relief valves simultaneously and subsequent freezing in service can render the valves temporarily inoperative.
Remedy: Crane will perform an inspection and provide instructions for ordering and installing the retrofit kit. The recall is expected to begin during july 2004. Owners should contact crane at 918-832-7305.
Model years: 1997
-
Vehicle speed control
On certain heavy duty trucks equipped with cummins c8.3g and l10g electronic control modules (ECM), the ECM does not have the ability to detect a throttle fail-safe engine shutdown command. This could result in an unanticipated, uncommanded open throttle condition without warning.
Remedy: Cummins will notify the customers and replace the ECM. Owners should contact cummins at 1-800-343-7357 or crane carrier at 1-918-836-1651.
Model years: 1997
-
Automatic (service brakes)
On certain trailers equipped with a specific combination of reyco suspension, eaton drive axle, and bendix slack adjusters, the failure of a drive axle slack adjuster to automatically adjust as required to compensate for brake wear, will cause an out of adjustment condition. If this condition occurs and is not identified and corrected…
Remedy: Crane carrier will supply, at no charge, gunite slack adjusters and installation instructions to replace the existing bendix slack adjusters on the drive axle. The installing facility will be reimbursed by crane for…
-
Labels (equipment)
On certain tag and pusher axle assemblies purchased from ridewell, the axle assemblies have an actual weight rating less than that specified on the label and therefore fail to comply with the requirements of part 567.5, "certification."
Remedy: Crane will provide owners with replacement vehicle certification labels and installation instructions. Owner notification began october 4, 2002. Owners who do not receive the free remedy within a reasonable time should…
Other Crane models
- Packer1 complaints
- C20 complaints
- Chassis0 complaints
- Crane0 complaints
- Dr0 complaints
- DR201040 complaints
- Ifl0 complaints
- Ir0 complaints
Source: NHTSA recall and complaint databases and EPA fuel economy data, October 2026. Complaint counts are owner reports to NHTSA, not verified defects. Recall counts are safety campaigns that list this model year; whether a particular car was already repaired depends on its VIN. How this data is compiled.