Bigdog Bulldog Recalls & Complaints by Model Year
NHTSA lists 13 safety recalls and 0 owner complaints across 3 model years of the Bigdog Bulldog (2004–2007).
Pick your Bigdog Bulldog model year
| Model year | Recalls | Complaints |
|---|---|---|
| 2007 Bigdog Bulldog | 2 | 0 |
| 2005 Bigdog Bulldog | 9 | 0 |
| 2004 Bigdog Bulldog | 4 | 0 |
All Bigdog Bulldog recalls (13)
Every NHTSA safety campaign that lists a Bigdog Bulldog, most recent first, with the model years each one covers.
-
Body (structure)
On certain motorcycles, the rear fender strut attaching bolts can fail allowing the rear fender to detach from the motorcycle.
Remedy: Dealers will remove existing strut bolts and replace with higher tensile strength attaching bolts and updated washers. Higher torque values will be observed when installing the replacement fasteners. The recall began…
-
Alternator/generator/regulator (electrical system)
On certain motorcycles, a warped bus bar within the voltage regulator can cause a short circuit.
Remedy: Dealers will replace the existing circuit breaker located between the voltage regulator positive battery lead (b+ lead) and the positive battery terminal with an alternative circuit protection device that will prevent…
Model years: 2005
-
Electrical system
On certain motorcycles, the tachometer board may have been improperly installed.
Remedy: Dealers will isolate the tachometer board from the housing. The recallbegan on august 27, 2007. Owners may contact big dog at 1-316-219-9129 or e-mail at customer.service@bigdogmotorcycles.com.
Model years: 2007
-
Structure
On certain motorcycles, the long pivot bolt may bend or break during normal operation of the motorcycle.
Remedy: Dealers will replace the long pivot bolt and, if necessary, straighten the rear frame side panel. The short left side pivot bolt and pivot shaft may also be replaced free of charge. The recall began on november 1,…
Model years: 2005
-
Electrical system
On certain motorcycles, the electronic harness control (ehc) module can fail resulting in a total shut down of the vehicle's electronic power.
Remedy: Dealers will replace the ehc modules free of charge. The recall began on september 19, 2006. Owners may contact big dog at 316-267-9121.
Model years: 2005
-
Electrical system: module
On certain motorcycles, the ignition modules are oriented within the battery tray in a way that makes the ignition module susceptible to vibration.
Remedy: Dealers will install a new ignition module mounting system free of charge. The recall began on august 25, 2006. Owners may contact big dog at 316-267-9121.
Model years: 2005
-
Structure
On certain motorcycles, the front fender brackets could fail allowing the front fender to detach.
Remedy: Dealers will replace the front fender brackets free of charge. (big dog recalled certain bulldog motorcycles in may 2005. Big dog revised the repair instructions and is recalling all the 2005 bulldog motorcycles. If…
Model years: 2005
-
Kickstand/center stand (structure)
On certain motorcycles, the kickstand spring may stretch and detach from the mounting bracket or the kickstand.
Remedy: Dealers will install a new kickstand spring free of charge. The recall began on february 17, 2006. Owners may contact big dog at 316-267-9121.
-
Lugs/nuts/bolts/studs (wheels)
On certain motorcycles, the rear wheel hub bolts could loosen and back out allowing the hub and brake rotor to detach from the wheel with an associated loss of stopping power.
Remedy: Dealers will remove, clean and reattach the rear hub bolts free of charge. The recall began on october 14, 2005. Owners may contact big dog at 1-312-267-9121.
Model years: 2005
-
Structure
On certain motorcycles, the front fender brackets could fail allowing the front fender to detach.
Remedy: Dealers will replace the front fender brackets free of charge. The recall began on may 31, 2005. This recall campaign has been superseded by 06v122.
Model years: 2005
-
Kickstand/center stand (structure)
On certain motorcycles, the kickstand spring attaching stud may break off allowing the kickstand to deploy into the extended position.
Remedy: Dealers will inspect and install a new kickstand unit. The recall began on december 20, 2004. Owners should contact big dog at 316-267-9121.
Model years: 2004
-
Steering wheel/handle bar (steering)
On certain motorcycles, a screw may become loose in the handlebar control due to the lack of a lock washer and loctite.
Remedy: Dealers will install a lock washer and loctite. Owner notification began on april 12, 2004. Owners should contact big dog at 1-316-219-7006.
Model years: 2004
-
Master cylinder (service brakes)
On certain motorcycles, the piston in the rear master cylinder may have been improperly sized, which could cause the rear brakes to drag or lockup.
Remedy: Dealers will remove the piston from the rear master cylinder and replace it with a new piston. Owner notification began on april 12, 2004. Owners should contact big dog at 1-316-267-9121.
Model years: 2004
Other Bigdog models
- Chopper21 complaints
- Pitbull11 complaints
- Daytec Chopper4 complaints
- Mastiff4 complaints
- Bull Dog3 complaints
- Ridgeback3 complaints
- Pit Bull2 complaints
- Bdm1 complaints
Source: NHTSA recall and complaint databases and EPA fuel economy data, October 2026. Complaint counts are owner reports to NHTSA, not verified defects. Recall counts are safety campaigns that list this model year; whether a particular car was already repaired depends on its VIN. How this data is compiled.