NHTSA Recall 10V485000: Equipment
ALTEC INDUSTRIES INC. reported this safety recall to NHTSA on , covering an estimated 578 vehicles. It affects 2008–2009 Altec Altec.
| NHTSA campaign | 10V485000 |
|---|---|
| Manufacturer campaign | CSN 537 |
| Component | EQUIPMENT |
| Report received | October 7, 2010 |
| Owner notification | October 29, 2010 |
| Initiated by | Manufacturer |
Defect
Altec is recalling certain model year 2008-2009 digger derricks utility vehicles built from september 2008 through may 2009. The digger bail pins installed on these vehicles were not properly heat treated and can develop cracks during auger use. The digger could become separated from the digger bail allowing the auger/digger assembly to swing freely from the digger hoses.
Safety risk
A swinging auger/digger could strike a bystander causing serious injury or death.
Remedy
Dealers will replace the pins free of charge. The safety recall began on october 29, 2010. Owners may contact altec at 1-877-462-5832.
Notes
Altec safety recall no. Csn 537.owners may also contact the national highway traffic safety administration's vehicle safety hotline at 1-888-327-4236 (tty 1-800-424-9153), or go to <a href=http://www.safercar.gov>http://www.safercar.gov</a> .
Vehicles covered by recall 10V485000
Being listed here means the campaign covers the model year, not that every car was built with the defect or is still unrepaired. Enter your VIN above to check your specific vehicle. Recall repairs are free at authorised dealers. Source: NHTSA, October 2026.